Karcher K 260 M User Manual - Step 4

You will need a standard screw driver OR a Torx T-25 screw driver

Step 4

Slide the spray wand

extension into the gun. Turn the wand

collar clockwise onto the gun threads

until tight.

3

ASSEMBLY INSTRUCTIONS

Step 3

Slide the hose caddy into the handle

slots and snap into place.

Step 1

Attach the mobile adapter brackets to

the pressure washer. Align holes on the bottom 

of the pressure washer as shown and tighten the

4 screws.

Step 2

Spread handle sides 

apart and align with slotted areas of

mobile adapter brackets and snap into

position. Tighten the 4 screws.

Water Supply 

(Cold Water Only)

• Water hose must be at least 3/4 inch in

diameter.

• Flow rate of water supply must not fall

below 2.5 GPM (gallons per minute).

• Flow rate can be determined by running

the water for one minute into an empty

5-gallon container.

IMPORTANT PRECAUTIONS  – 

continued

• The water supply temperature must not

exceed 104°F/40°C.

• Never use the pressure washer to draw in

water contaminated with solvents, e.g.

paint thinners, gasoline, oil, etc.

• Always prevent debris from being drawn

into the unit by using a clean water source.