Karcher K 360 M Operator's Manual - page 4
4
Step 1
Slide each of the
mobile adapter brackets to
the pressure washer. Align
the pegs and holes on the
brackets. Insert the 4 screws
and tighten as shown.
Step 4/5
Pull out the locking slide from the right side of
the trigger gun handle, and insert the small end of the high
pressure hose into place. Push the locking slide back into the
trigger gun to lock the hose in position.
Step 2
Slide the handle
onto the mobile adapter
brackets as shown, insert
screws and tighten.
IMPORTANT PRECAUTIONS continued
ASSEMBLY INSTRUCTIONS
Water Supply
(Cold Water Only)
Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water could lead
to the unit being damaged. To avoid this
risk, we recommend fitting a filter.
Always prevent debris from being drawn
into the unit by using a clean water source
and an accessory water filter if required.
Water hose must be at least 3/4 inch in
diameter.
Flow rate of water supply must not fall
below 2 GPM (gallons per minute).
Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
The water supply temperature must not
exceed 104°F/40°C.
Step 3
Slide the hose
caddy into the handle slots
and snap into place.