Karcher KM 90/60 R LPG Adv Manual

Summary of KM 90/60 R LPG Adv

  • Page 1

    Www .Kaercher .Com/register-and-win km 90/60 r lpg adv 59646800 08/13.

  • Page 2

    - 1 please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent own- ers. Please read the safety instructions before start-up! Your sales outlet should be informed about any transit damage noted when unpacking th...

  • Page 3

    - 2 use this sweeper only as directed in these operating instructions. – this sweeper has been designed to sweep dirt and debris from outdoor sur- faces. – the machine is not suitable for being driven on public roads. – any use extending beyond this is not considered as proper use. The manu- facture...

  • Page 4

    - 3 – all persons handling liquid gases are li- able to acquaint themselves with the special properties of the liquefied gases for hazard-free handling of operations. The current documentation is always to be kept with the sweeper. – propellant-operated units are to be checked at regular intervals, ...

  • Page 5

    - 4 1 operating field 2 steering wheel 3 lever for seat adjustment 4 seat (with seat contact switch) 5 holder for gas cylinder 6 gas cylinder 7 holding rail for home base 8 cover 9 gas engine 10 stop switch 11 rear wheel 12 waste container (both sides) 13 roller brush access 14 front sealing strip 1...

  • Page 6

    - 5 danger danger of crushing while closing the ma- chine cover. Hence, lower the machine cover slowly. Prior to commissioning, maintenance or adjustment tasks, the appliance cover must be opened. Grab the front of the appliance cover and fold it back together with the seat. Note: slowly open the ap...

  • Page 7

    - 6 place the cylinder in such a way that the connection threading of the locking valve vertically points upwards. Note: a fitting position towards the top is important for the function of the gas motor, it requires a gaseous extraction from the gas bottle. Close the bracket closure. Attach safety s...

  • Page 8

    - 7 note: to achieve an optimum cleaning re- sult, the driving speed should be adjusted to take specific situations into account. Note: during operation, the waste contain- er should be emptied at regular intervals. Note: when cleaning surfaces, only lower the roller brush. Note: also lower side bru...

  • Page 9

    - 8 switch off the appliance and remove the ignition key prior to performing any cleaning or maintenance tasks on the appliance, replacing parts or switching over to another function. Always disconnect the battery when working on the electrics. – maintenance work may only be carried out by approved ...

  • Page 10

    - 9 please observe the following warning notes when handling batteries: danger risk of explosion! Do not put tools or similar on the battery, i.E. On the terminal poles and cell connectors. Danger risk of injury! Ensure that wounds never come into contact with lead. Always clean your hands after hav...

  • Page 11

    - 10 danger risk of burns on account of hot surfaces! Allow engine to cool down. Wait for at least 5 minutes after switch- ing off the engine before checking the engine oil fill level. Open the device hood. 1 oil drain hose 2 oil dipstick unscrew and withdraw oil dipstick. Wipe off and insert the oi...

  • Page 12

    - 11 park the sweeper on an even surface. Set programme switch to step 1 (driv- ing). Roller brush is raised. Turn ignition key to "0" and remove it. Secure the machine with wheel chock(s) to prevent it from rolling away. Remove belts or cords from roller brush. Note: the side brush floating mountin...

  • Page 13

    - 12 side sealing strips slightly loosen retaining nuts for the side sealing strip (to replace, unscrew). Screw on new sealing strip without fully tightening the nuts. To set the floor clearance, insert a sheet with a thickness of between 1 and 3 mm under the sealing strip. Adjust sealing strip. Tig...

  • Page 14

    - 13 troubleshooting fault remedy appliance cannot be started sit on the driver seat, the seat contact switch gets activated. Check, if the stop switch on the combustion engine is in the "on" position. Gas bottle empty - replace gas bottle. Gas removal valve closed - open the valve by turning it in ...

  • Page 15

    - 14 technical specifications km 90/60 r lpg adv machine data length x width x height mm 1695 x 1060 x 1300 net weight (transport weight) kg 280 permissible overall weight kg 440 driving speed km/h 8 cleaning speed km/h 4 climbing capability (max.) % 16 roller brush diameter mm 250 roller brush widt...

  • Page 16

    - 15 we hereby declare that the machine de- scribed below complies with the relevant basic safety and health requirements of the eu directives, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is m...

  • Page 18

    Http://www.Kaercher.Com/dealersearch.