Karcher MC 6430 User Manual - page 7
EN | 21
EN
Preparation of Remote Control
Remove (gently pull out) the plastic tab from the battery compartment at the rear of the remote
control.
Test the remote control by pointing it towards the remote control sensor on the unit and pressing
the On/Standby key to check that the unit switches on properly using the remote control.
Digital Clock Function
The set has a built-in digital clock, which is displayed when the set is in “standby mode”. In this situa-
tion the blue backlight is normally dimmed.
Setting the Time
1.
Switch the unit to stand-by mode.
2.
Press & hold the CLOCK SET button for 3 seconds. The display now shows
12
hour or
24
hour
ÀDVKLQJ
3.
Press
TUNE UP or
TUNE DOWN to select 12-hour or 24-hour clock display format and
press the CLOCK SET
EXWWRQWRFRQ¿UP\RXUVHOHFWLRQ
4.
Press
TUNE UP or
TUNE DOWN repeatedly to set the correct hour in the display and
press CLOCK SET
WRFRQ¿UP
5.
Press
TUNE UP or
TUNE DOWN repeatedly to set the correct minute in the display and
press CLOCK SET
WRFRQ¿UP
6.
Correct time is now set and will be shown in the display.
Note:
:KHQWKHGLJLWDOFORFNLVQRWVHWWKHGLJLWDOFORFNGLVSOD\LVFRQWLQXRXVO\ÀDVKLQJWRLQGLFDWHWKDW
the correct time has not yet been set.
Automatic Power On/Off Timer Function
This set has a timer function to enable you to program the unit to automatically switch “on” or “off” at
preset times. This is useful as a morning alarm clock:
Setting the Timer
1.
Press and hold TIMER key (on remote control). The “TIMER ON” symbol appears in the display.
2.
Press
TUNE UP or
TUNE DOWN to adjust the hour of the desired “on” time and then
press TIMER
NH\WRFRQ¿UP
3.
Press
TUNE UP or
TUNE DOWN to adjust the minutes of the desired “On” time and then
press TIMER
NH\WRFRQ¿UP
4.
Now the wording in the display changes to show “TIMER OFF”.
5.
Press
TUNE UP or
TUNE DOWN keys to adjust the hour of the desired “Off” time and then
press TIMER
WRFRQ¿UP
6.
Press
TUNE UP or
TUNE DOWN to adjust the minutes of the desired “Off” time and then
press TIMER
WRFRQ¿UP
7.
Now the display will indicate the “Wake Up Mode” (Tuner, CD, USB or Card). Press
TUNE UP
to choose the desired mode an press TIMER
WRFRQ¿UP
8.
The display then shows the “Wake Up Volume Level” (loudness). Press
TUNE UP or
TUNE DOWN to increase or decrease the volume level to be used for the music to be played
when the timer switches on the unit at the preset time.
9.
Press TIMER
WRFRQ¿UP
10. Finally the display will cycle through all settings and then the unit will return to the normal display,
except that the
symbol will be shown, to indicate that you have programmed an On/Off Alarm
setting.
11. In case you wish to disable the timer, press the TIMER key once and the
symbol will disap-
pear.