Karcher RA 2040 User Manual - page 24
24 | EN
•
To turn the light on, press the
LIGHT ON/OFF
button on the unit.
•
The direction of the light can be adjusted. Only do this carefully.
•
To turn the light off, press the
LIGHT ON/OFF
button once again.
Sleep Function
When the unit is switched on you can select a time intervall after which the unit switches itself auto-
matically into standby mode.
•
Press the
SLEEP
button on the remote control repeatedly until the desired time is reached. The
display will show “SLEEP”.
•
With the sleep timer activated you can check how much time is left until the unit switches itself
into standby by pressing the
SLEEP
button once.
•
To deactivate the sleep timer, press the
SLEEP
button repeatedly until “SLEEP” disappears from
the display.
Radio
Playing the Radio
1. Press the
POWER
button to switch the unit on.
2. Press the
FUNCTION
button to select the FM Radio function (“FM” is shown in the display).
3. To automatically tune to the previously/next available radio station, press and hold for 2 seconds
the |◄◄ or ►
►
| button. The tuning will stop at the first station found.
4.
To manually tune to a radio station, press the |◄◄ or ►
►
| button repeatedly until you reach the
desired frequency.
5. This unit supports FM Stereo reception. If a station is found which broadcasts in stereo, the
display will show the stereo symbol.
Station Memory
This unit enables you to store up to 20 radio channels.
1. Search for a desired radio station as described above.
2. To store this radio station in the memory, press the
PROG.
button on the unit or the
MEM PROG
button on the remote control. The first memory preset “P01” will blink in the display.
3.
By pressing the |◄◄ / ►
►
| buttons, select the preset (P01 - P20) on which you would like to
store the tuned in radio station.
4. Press the
PROG.
button the unit or the
MEM PROG
button on the remote control ance again to
confirm.
5. Repeat steps 1 - 4 to store up to 20 radio stations.
Note:
A stored frequency can only be erased by storing another frequency in its place.
Selecting a Stored Radio Station
In order to recall a stored radio station, turn on the radio and press the
M-
/
M+
buttons repeatedly until
you reach the desired memory preset.
Note:
When you disconnect the AC power or in case of a power outage, the preset stations will be lost
and must be reset, unless you have backup batteries installed.
CD Player
CD Playback
1. Press the
POWER
button to switch the unit on.
2. Press the
FUNCTION
button to select the CD function (CD symbol is shown in the display).
3. Press the
OPEN/CLOSE
button to open the CD drawer.
4. Insert a disc with the printed side facing up. Ensure that the disc is inserted correctly.