Karcher Silver Star User Manual - page 9
English - 9
level should between the MAX and MIN.
2. Place the funnel into the funnel support, make sure it is assembled correctly. The detail steps
refer to the figure at the end of instruction. Then put the filter correctly.
3. Add coffee ground into filter. Usually a cup of coffee need a level spoon of coffee ground, but you
may adjust according to you taste properly.
4. Insert the carafe on keeping warm plate horizontally.
Note: the tuber of carafe must be inserted into the keep warm plate.
5. Plug the power cord into the outlet, the LCD will display “12:00 “ (fig.1).
6. Press “ON/OFF” button, the “RUN” indicator will be illuminated. The appliance
will begin working.
Note: You can take out carafe, pour and serve at any time. The appliance will
stop dripping automatically. But the time can not exceed 30 seconds.
7. Do not open the tank cover when the coffee maker is operating. The flow back of
hot water will damage the appliance.
8. You can take out carafe, pour and serve when finish brewing (about one minute later after the
coffee stops dripping out.)
Note: the coffee you get will less than the water you have inputted in, as some water is absorbed
by coffee ground. As safety is concerned, you had better cover the lid of carafe when pouring,
that is good to keep warm too.
9. Always turn the coffee maker off and unplug the power cord from the electrical outlet when the
coffee maker is not in use.
Note: pay attention to pour the coffee out, otherwise you may be hurt as the temperature of cof-
fee just finished is high.
Automatic start function
If you do not want the coffee maker start operation immediately, for example now
it is 5:10 pm, you hope that the coffee maker will automatically start at 8:15 in the
evening, first follow steps 1 to 5 of above section, then you can set the automatic
start function as follows:
1. Press “ON/OFF” twice, the “AUTO” indicator will be illuminated.
2. Press “PROG” button, the “LCD” will display “CLOCK” (fig.2). Set the current
time by pressing the “HOUR” and “MIN”.
Note: the time cycle is 24 hours. Select desired time by pressing the “HOUR”
and “MIN” continuously.
3. Press “PROG” button, the “LCD” will display “TIMER”, then set the automatic start time by press-
ing the “HOUR” and “MIN” (fig.3).
At 8:15 in the evening the “AUTO” indicator will be extinguished, and the “RUN” will be illuminated.
The appliance will start automatically. After brewing, you can replace the carafe on keeping warm
plate. Once the coffee maker is energized, the coffee can be kept warm.
Note: If leave the coffee maker unattended for 2 hours, the appliance will be cut off power automati-
cally.
Cleaning and maintenance
CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do not
immerse cord, plug or unit in water or liquid. After each use, always make sure plug is first removed
from wall outlet.
1. Clean the filter, carafe and carafe lid after each use in hot, sudsy water.
2. Wipe the product’s exterior surface with a soft, damp cloth to remove stains.
3. Water droplets may buildup in the area above the Filter and drip onto the product base during
brewing. To control the dripping, wipe off the area with a clean, dry cloth after each use of the
product.