Karcher T 550 T-Racer Manual - page 9
– 3
The most commonly used KÄRCHER detergents can
be purchased ready to use in their Plug 'n' Clean deter-
gent bottles with locking lids. This will make the pesky
refilling and filling processes redundant.
Illustration
Remove the lid from the Plug 'n' Clean detergent
bottle and press the detergent bottle into the deter-
gent connection with the opening facing down.
Adjust the suction volume of the detergent solution
by means of the dosage regulator for detergents.
Note
–
Bring the bottleneck into an upright position to com-
pletely empty the detergent bottle.
–
Turn the detergent bottle around after cleaning,
close it and place it in the retainer for the Plug 'n'
Clean detergent bottle.
–
Clean gravel surfaces without detergent.
–
Do not adjust the detergent supply via the dosing
regulator for detergents while under pressure.
Fasten the T-Racer directly to the high-pressure gun.
1
Press the bayonet connection of the T-Racer into
the connection of the high-pressure gun, then turn
by 90° until it locks into place.
2
Tighten the union nut.
Adjust the twist grip "Power" in accordance with the
surface to be cleaned.
몇 CAUTION
Always hold the T-Racer at the handle while cleaning
the walls.
Illustration
The turning handle "power" is used to change the dis-
tance of the high-pressure nozzles to the surface to be
cleaned.
Illustration
Sturdy surfaces (e.g. tiles, concrete, stone)
Set turning handle "power" to "HARD".
For the effective cleaning of hard-to-remove con-
tamination.
Sensitive surfaces (e.g. wood)
Set turning handle "power" to "SOFT".
For the gentle cleaning of sensitive surfaces.
Illustration
For normal surface cleaning, operate the foot
switch for surface cleaning (a).
A water stream will be emitted from the two high-
pressure nozzles in the rotor arm.
Illustration
For edge and corner cleaning, operate the foot
switch for edge cleaning (b).
A water stream will be emitted from green high-
pressure nozzle.
Note
For edge and corner cleaning no detergent is added.
In order to achieve the optimum cleaning result, guide
the T-Racer along the corners.
Illustration
The detergent supply is adjusted by means of the
dosing regulator for detergent.
You can use the extension pipe with any Kärcher acces-
sory.
Use a moist cloth and clean the appliance after use.
Store the appliance in a frost free area.
The device can be suspended into the KÄRCHER or-
ganiser for storage.
Pressure washer does not build up pressure or is
pulsating.
Dismantle the high-pressure nozzles, check the
high-pressure nozzles for damage, rinse the T-
Racer with clean water then reinstall the high-pres-
sure nozzles.
You need to use the matching high pressure noz-
zles to ensure that your high pressure cleaner
works properly.
Select and install the high-pressure nozzles in ac-
cordance with the pressure washer used.
Check the settings at the dosage regulator for de-
tergent.
Check whether the Plug 'n' Clean detergent bottle
is placed into the detergent connection facing
down.
Working with detergent
Cleaning wall surfaces
Control elements
"Power" turning handle
Foot pedal for surface cleaning
Foot pedal for edge cleaning
Dosage regulator for detergent
Tip
Care
Troubleshooting
No detergent infeed
12
EN