Karcher T-Racer T 400 Plus User Manual - Description of The Appliance
– 5
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
See page 2, illustration
1 Casing
2 Handle
3 Turning handle "power" (to adjust the
height of the nozzles)
4 Foot pedal for edge cleaning
5 Foot pedal for surface cleaning
6 Bayonet connection with safety cover
7 Extension tubes (two tubes)
8 Rotor arm
9 Green high-pressure nozzle
10 Yellow high-pressure nozzles (2 pieces)
11 Grey high-pressure nozzles (2 pieces)
12 Safety clip
13 Protective grid
You need to use the matching high-pres-
sure nozzles to ensure that your high-pres-
sure cleaner works properly.
Note: Nominal pressure (p): See Operating
Instructions or type plate of your high-pres-
sure cleaner.
e.g.: K 6 – K 7, Kärcher 600 – Kärcher 770
Use yellow high-pressure nozzles.
Note:The yellow high-pressure nozzles
have already been installed.
e.g.: K 4 – K 5, Kärcher 201 – Kärcher 560
Use grey high-pressure nozzles.
Illustration
1 Loosen the safety clamp with a screw-
driver.
2 Remove the protective grid.
3 Change the high pressure nozzles.
4 Mount the protective grid on the pin.
5 Push the safety clamp in until it locks.
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
Illustration
1 Screw the two extension pipes together.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Adjust the turning handle "power" as
per the surface to be cleaned
Description of the Appliance
Preparing the Appliance
Selecting the high-pressure noz-
zles
High-pressure cleaner with nominal
pressure (p) of 13 MPa (130 bar) to 16
MPa (160 bar)
High-pressure cleaner with nominal
voltage (p) lesser than 13 MPa (130 bar)
Changing the high-pressure nozzles
a Remove the clip.
b Pull out the yellow high-pressure noz-
zle.
c Insert the grey high-pressure nozzle.
d Re-insert the clip.
Application
Cleaning floor surfaces
8
EN