Karcher UR 1015 User Manual - page 15
EN | 15
EN
AC POWER CONNECTION
Make sure that the AC power cord is your local voltage cord, [ use VOLTAGE SELECTOR-optional
(#19)] and then plug AC POWER CORD (#16) into the AC wall outlet.
BACK UP BATTERY
1. Open the BATTERY DOOR (#20) by pressing the battery cover buckle.
2. Install a good quality 9 Volts battery (not included) in the battery compartment at the bottom of the
unit.
3. Close the BATTERYDOOR (#20).
4. In the event of a power failure, the radio and time display will stop operating, but this battery will
keep the clock time going. This means that although you will not be able to see the time, the bat-
tery - operated clock will continue operating.
5. When the power failure is over, the LED DISPLAY (#14) will again show the correct time without
need for readjustment.
RADIO OPERATION
1. Turn on the unit by sliding the MODE switch (#2) to ON position.
2. Slide the BAND switch (# 10) to the required wave band.
3. Rotate the TUNING knob (#11) to obtain the desired radio station, the station frequency is indicated
in the DIAL POINTER (#15).
The FM WIRE ANTENNA (# 17) located on the rear of the unit is for FM reception. The wire should
be fully extended and positioned for optimum reception.
For AM reception there is a built in ferrite aerial. Rotate the unit to the position giving best reception
4. Adjust the VOLUME/OFF knob (#1) to obtain the desired sound level.
5. To turn off the radio, slide the MODE switch (#2) to OFF position.
SETTING THE CLOCK
After plugging the unit in or after a power failure, the LED DISPLAY(#14) will show 0:00 in standby
mode.
1. In standby mode, press and hold the TIME SET button (#6).
2. Press the HOUR button (# 8) to adjust the hour.
3. Press the MIN button (#9) to adjust the minute.
NOTE: The clock uses a 12 hour display with a PM indicator.
Ensure that the correct 12 hours cycle is selected.
SETTING THE ALARM TIME
The alarm can be set to wake you by Buzzer or Radio.
1. Press and hold the ALARM SET/OFF button (#4).
2. Press the HOUR button (#8) to adjust the hour.
3. Press the MIN button (#9) to adjust the minute.
4. Slide the MODE switch (#2) to AUTO position, the alarm function is turn on and the ALARM INDI-
CATOR (13) will light up.
SLEEP TO MUSIC
1. Slide the Mode switch (#2) to OFF position.
2. Press the SLEEP button (#3), the unit will enter to radio mode, and 0:59 will appear on the LED
DISPLAY (#14), indicating that the radio will shut off automatically in 59 minutes. If you want to
change the automatically shut off time, hold down the SLEEP button (#3) with one finger, and