Karcher UR 1110 User Manual - page 10
10 - EN
1.
ON/OFF/AUTO
2.
LED DISPLAY
3.
AUTO INDICATOR
4.
SNOOZE/SLEEP OFF
5.
ALARM SET/OFF
6.
TIME SET
7.
SLEEP SET
8.
HOUR/MINUTE INDICATOR
9.
HOUR SET
10.
MINUTE SET
11.
VOLUME CONTROL / BUZZ
12.
WAVE BAND
13.
TUNING CONTROL
14.
BATTERY BACK-UP
15.
FM ANTENNA WIRE
16.
AC POWER CORD
17.
POINTER
18.
PROJECTION ON/OFF
19.
PROJECTION
20.
TIME SET BUTTON FOR PROJECTION
21.
HOUR BUTTON FOR PROJECTION
22.
MINUTE BUTTON FOR PROJECTION
23.
FOCUS ADJUSTMENT
AC POWER OPERATION
Before connecting to the power supply ensure that the supply corresponds to the information on the rating
label on the bottom of the apparatus.
CLOCK
1.
Set the ON/OFF/AUTO switch (1) to ‘OFF’ connect the Main Cord to the power supply. The clock
display will flash on and off indicating a power interruption and that the display time is incorrect.
2.
To set the correct time, press the TIME SET button (6) and MINUTE SET button (10), or HOUR SET
button (9), together, until the correct time is displayed.
3.
Open the Clock Battery Compartment door and fit a 9V battery. The purpose of this battery is to store
the information relating to alarm time. And to keep the clock functioning in the event of disconnection
from the mains supply or power interrruption. Should this occur. The clock will continue to keep time,
but will not display.
The led digital clock and the projection clock must be set separately.
TIME SETTING FOR PROJECTION
1.
Switch the projection switch to the ‘ON’ position.
2.
To preset the HOURS, press simultaneously the HOUR BUTTON (21) and the TIME BUTTON (20),
keep them depressed until the hour digits to be preset are displayed.
3.
To preset the MINUTES, press simultaneously the MINUTE BUTTON (22) and the TIME BUTTON
(20). Keep them depressed until the minute digits to be preset are displayed.
4.
Focus setting: To adjust the projection clock definition by turning the FOCUS (23) until the project’s
time is clearly shown on the ceiling or wall.
Note: PROJECTS TIME IMAGE ON THE CEILING OR WALL OF A DARKENED ROOM.
MAXIMUM PROJECTION DISTANCE IS 3-9 FEET.
TO SET OR RESET THE ALARM TIME
1.
Press and hold the ALARM SET/OFF button (5).
2.
While holding the ALARM SET/OFF button (5) press the HOUR SET button (9) and MINUTE SET but-
ton (10) to advance the time until the desired alarm time is shown on the display.