Karcher UR 1306 User Manual - page 17
EN | 17
EN
Stopping an Active Alarm
•
When the alarm is sounding, press the ■ STOP/PRESET button or the STANDBY button to
turn it off. The alarm will come on again on the next day at the set time.
Snooze Function
The snooze function allows you to delay an active alarm for approximately 10 minutes. To do so, press
the SNOOZE button once while the alarm is active. The alarm will stop and come on again after ap-
proximately 10 minutes. During this time “SNOOZE” is flashing in the display.
To cancel the snooze function, press the ■ STOP/PRESET button.
Dimmer
The display can be dimmed in 3 levels. To select between the settings press the DIMMER button.
Radio
1.
Switch the unit on as described previously.
2.
Select the radio mode by pressing the SOURCE button in case the unit is not already in radio
mode. The frequency will be shown in the display.
3.
To select between AM and FM bands, press the
PLAY/PAUSE/BAND button.
4.
Select a desired radio station by pressing the
or
button repeatedly.
5.
To automatically search for the next available radio station, press and hold for 2 seconds the
or
button.
For a better reception
•
completely unroll the FM wire antenna for FM.
•
reposition the unit for AM.
Radio Station Presets
This unit enables you to store up to 10 radio stations per band.
1.
Tune to a radio station which you would like to store.
2.
Press and hold for 2 seconds the ■ STOP/PRESET button. The presets will start flashing (e.g. “P
01”).
3.
Select a desired preset place from P 01 - P 10 on which you want to store the current frequency
by pressing the
or
button.
4.
Press the ■ STOP/PRESET button again to confirm your setting.
5.
Repeat steps 1 - 4 to store up to 10 frequencies.
6.
To recall a stored frequency, press the ■ STOP/PRESET button and then the or button
until you reach the desired preset.
Note:
•
If the unit gets disconnected from the power supply, all stored channels will be lost and will have
to be reset.
CD Operation
Playing Discs
1.
Switch the unit on and select the CD mode by pressing the SOURCE button.
2.
Open the CD door by gently pressing on the OPEN/CLOSE tab. Insert a disc with the printed
side facing up.
3.
Close the CD door. The CD is being read and the total number of tracks will then be shown in the
display.
4.
Start the playback by pressing the
PLAY/PAUSE/BAND button.
5.
To temporarily stop the playback (pause), press the
PLAY/PAUSE/BAND button once. Press