Karcher UR 1310i User Manual - page 19
EN
EN - 19
happens, please try again with a different iPhone / iPod if needed.
Note: It is possible to have up to 59 seconds difference between the clock radio
and synced iPod / iPhone.
Setting Clock Manually
The unit must be in standby mode.
1.
Press and hold the clock SET/MEMORY button ; “12 Hr” will blink. Press
the TUNE UP or TUNE DOWN button to set the unit to the 24 hour (24 Hr)
mode or 12 Hour (12 Hr) mode.
2.
Press the clock SET/MEMORY button and the hours will blink.
3.
Press the TUNE UP or DOWN to set the current hour.
4.
Then press the clock SET/MEMORY button again; the minute digits will
blink.
5.
Press the TUNE UP or TUNE DOWN to set the current minutes.
6.
When done and you press clock SET/MEMORY button once again to store
your setting.
Setting Alarm Time and Mode
This unit allows you to set 2 different alarm times. To preview the set alarm time
and alarm mode press one of the ALARM buttons (AL.1 or AL.2) once while the
unit is in standby mode and clock display. After 3 seconds the display switches
back to the clock display.
Setting alarm time and mode:
1.
Enter the alarm preview mode by pressing one of the ALARM buttons (AL.1
or AL.2) shortly.
2.
While the display is showing the alarm time press and hold the relevant
ALARM button for 3 seconds. The hours will blink.
3.
Press TUNE UP or TUNE DOWN to set the alarm hour.
4.
Press the ALARM button again; the minute digits will blink. Press TUNE UP
or TUNE DOWN to set the alarm minutes.
5.
Press the ALARM button to select the sound mode (Buzzer, Radio, iPhone /
ipod) for the alarm by pressing TUNE UP or TUNE DOWN.
6.
Press the ALARM button once again to finish the setting. After a few sec-
onds the display will switch back to the clock display and show either
or
to indicate that the alarm is activated.
Activating/deactivating an alarm:
1.
To activate a previously set alarm, press and hold one of the alarm buttons
AL.1 or AL.2 for 2 seconds until the display shows either
or
. You can
also activate both alarms.
2.
The alarm will now go on at the set time and mode. The alarm volume will
gradually increase and it takes a few seconds until it can be heard. The