Karel DSS80 Owner's Manual - page 7
Karel DSS80 Easy To Use Owner’s Guide
Edition 3.2
5
II. PROGRAMMING & USING DSS80 KEYS
Each key of DSS80 can be assigned to the following 6 different functions activating
the relevant Programming Mode. Below, the keys to start the relevant Programming
Mode are given for each function.
1. Extensions-“S” key.
2. Lines-“T” key.
3. Common pool numbers-“C” key.
4. Private pool numbers-“M” key.
5. Some system features-“P” key.
6. Auto
Setting-“R” key.
•
P
ROGRAMMING MODE ENTRY
Press relevant key until the third “beep” to start the desired Programming
Mode. Program the DSS80 key as described in the following pages.
-
When DSS80 is put into Programming Mode, LEDs of the DSS80
Programming Keys are lit except for the one blinking which is used to put
DSS80 into Programming Mode.
-
When any DSS80 key is pressed to be programmed, its LED starts
blinking slowly and it turns off after successful programming.
-
If there are more keys to be programmed in the same Programming Mode
and if Programming Mode has not been exited, these keys can also be
programmed without the need to restart the Programming Mode using the
relevant key.
•
P
ROGRAMMING MODE EXIT
Press “E” key until the third “beep”.
-
DSS80 exits the programming mode automatically 30 seconds after the
last use of a DSS80 key. However, it is recommended to use “E” key to
exit Programming Mode so as to prevent any possible program errors.