Technical reference and user’s guide revaaa internal pager system control unit i caution! Since pg100-cu internal pager system control unit is an electronic-based product, the requirements below should be fulfilled to operate it with full capacity without being affected by the environmental factors:...
Technical reference and user’s guide revaaa internal pager system control unit ii preface chapters in this guide have been prepared in order to present detailed technical information to people who need hardware-based information about the pg100-cu internal pager system control, and instructing them ...
Technical reference and user’s guide revaaa internal pager system control unit technical introduction introduction to the pg100-cu unit the pg100-cu unit is one that transfers call information to several pg100-rf local pager devices and that provides synchronous operation of the transmitters. In cas...
Technical reference and user’s guide revaaa internal pager system control unit 3 installation preparation the pg100-cu internal pager system has been designed so as to be mounted on wall surfaces. First of all, the location to install the device should be determined. Such a location is supposed to p...
Technical reference and user’s guide revaaa internal pager system control unit exchange connection: connection to the ms series exchanges can be made over the kts interface and to the ds series exchanges over either kts or rs422 interfaces. Signal assignments for the kts/rs422 and rs232 connectors h...
Technical reference and user’s guide revaaa internal pager system control unit 7 8.
Technical reference and user’s guide revaaa internal pager system control unit 9 10
Technical reference and user’s guide revaaa internal pager system control unit 11 12.
