KAS crease matic 150 User Manual

Manual is about: programmable card creaser

Summary of crease matic 150

  • Page 1

    Kas http://www.Monomachines.Com http://www.Monomachines.Com.

  • Page 2

    Crease matic 150 the new crease matic 150 is a fully programmable card creaser developed specifically for the short to medium run digital print market. Designed and manufactured in the uk. It bridges the gap between desk top card creases and suction fed models. Over 2000 sheets per hour can be strea...

  • Page 3

    Crease matic 150 operation: the creasing machine has five (5) programs that are saved on power down. Each program may contain up to nine (9) crease positions. There is no limit to how close together, or how close to the sheet edge, the creases may be. On power up, the creaser will check the position...

  • Page 4

    Crease matic 150 operation (continued): in ‘run’ mode the feed motor and/or crease motor may be stopped at any time by pressing any of the four keys. To restart the feed motor, press the key. If the feed motor is stopped and the key is pressed, the sheet counter is reset to zero. If the feed motor i...

  • Page 5

    Crease matic 150 mechanical adjustment and maintenance: knife driver 1) knife depth adjustment blocks 2) screws for adjustment of rhs lay 3) bolts for adjustment of lhs lay rhs lay lhs lay crease block lhs lay support bar turn the power off. 1) knife depth adjustment: using a 13mm spanner loosen the...

  • Page 6

    New job setup: 1. Ensure crease matic is in ‘setup’ mode. Decimal 2. Push card gently to infeed wheels. The crease point in last position of screen and led off. Select matic will feed the card to the creasing blade. Job number to program, then press ‘crease’. 3. Press the ‘left’ key until distance f...

  • Page 7

    Cross left crease right power on reset memory sensor to crease = 16 edit sensor to crease distance setting if ‘9999’ displayed at start up. Press to reset knife setup mode last d.P. On screen exit to run index job setup job display job setup last d.P. On screen exit to run forward crease and save se...

  • Page 8

    Cross left crease right power on if ‘9999’ displayed at start up. Press to reset knife setup mode last d.P. On screen exit to run index job setup job display job setup last d.P. On screen exit to run forward crease and save setting back (slow) run mode green led start stop (if motor running) reset c...

  • Page 9

    Upper perforator wheel top perforating wheel is pushed against spring as perforator is closed do not adjust this screw upper shaft control wheel control wheel lower shaft lower perforating wheel 1/8”(3.17mm) 1/4” (6.35mm) position of perforating wheels when in open position position of perforating w...

  • Page 10

    Spring loaded pin shaft flat telescopic end piece upper perforating wheel collar top shaft control wheels control wheels lower perforating wheel smoother guides rule bottom shaft perforator unit http://www.Monomachines.Com http://www.Monomachines.Com.