Ls-8015-zw-mm-bg manual operation guide.
Page - 2 - of 8 ls-8015-zw-mm-bg general information: exit setting mode: enter * to exit the setting procedure, or wait for 10 seconds low battery warning: when the voltage drops below 5.2v after entering a valid code, the lock beeps for three times. Unlocking indicator: music sounds and motor rotat...
Page - 3 - of 8 types to operate the lock ： user code unlock: 6 digits user code emergency unlock: 8 digits programming code + 9 (for emergency) wireless :mobile or pc or pad manual key: turn the override key 90 degree clockwise, then turn the handle terms: programming code: 8 digits. The programmin...
Page - 4 - of 8 steps to setup a new lock (please follow the order ） a. Change programming code (for example, change to 23456789) {12345678}+{4}+{23456789}+{23456789} b. Add user code (for example, add 123456 to the lock) {23456789}+{1}+{123456 }+{123456} functions detail 1. How to change programmin...
Page - 5 - of 8 please be noted that the lock will not accept any user code but programming code only in vacation mode. {programming code}, disable vocation mode. 7. How to enable button beeps (on & off) function code: 6 {programming code}+{6}, toggle beep on/off. 8. How to enable/disable passage mo...
Page - 6 - of 8 b. If the lock has not been enrolled with any other gateway, lock sounds a short beep after 50sec indicating unenroll unsuccessfully. Unenroll operation is unnecessary. After restore factory default, the enroll status of z-wave is still effective. Z-wave generic information ： generic...
Page - 7 - of 8 device support command class 设备支持的命令类 included as no- secure node, nif response included as no- secure node, anti- theft protect, nif response included as secure node, nif response included as secure node, security support response included as secure node, anti- theft protect, nif re...
Page - 8 - of 8 basic set on(0xff) and off(0x00) command while vacation mode is enable and disable. Command_class_configuration device reserves 255 bytes memory store space use for upper application. Upper application could access the memory by configuration command class, default setting always set...
