Kasco Marine 3400HJF Owner's Manual

Other manuals for 3400HJF: Owner's Manual
Manual is about: Aerating Fountains

Summary of 3400HJF

  • Page 1

    Owners manual aerating fountains 3400jf & 3400hjf 4400jf & 4400hjf contents important safety. . . . Pg2 general instructions. . . . Pg2 cord gauge chart. . . . Pg3 unit specs. . . . Pg3 3400jf, 3400hjf parts included. . . . Pg4 3400jf, 3400hjf assembly. . . . Pg4 4400jf, 4400hjf parts included. . . ...

  • Page 2

    2 thanks we at kasco marine, inc. Would like to both thank and congratulate you on your purchase of the jf model aerating fountain. We appreciate you choosing kasco and for your purchase. Your decision to purchase kas- co’s jf model aerating fountain will not disappoint you. The jf model aerating fo...

  • Page 3

    3 tant to store them upside down if they are going to be sitting for long periods of time. Units that sit upright on a shelf for many months, or even years have a greater likelihood of seals drying out. Storing upside down will ensure oil is lubricating the seals and pre- vent drying. Cord gauge cha...

  • Page 4

    4 set of 5 interchangeable nozzles (5) 1. 3/8” x 2.25” bolt (1) 2. 3/8” x 4” bolt (1) 3. Linden nozzle (1) 4. Sequoia nozzle (1) 5. Juniper nozzle (1) 6. Willow nozzle (1) 7. Cypress nozzle (1) 8. Collar for cypress nozzle (1) also included: mesh screen (1) with cable ties (10) • mooring rope pipe w...

  • Page 5

    5 step six see “mesh screen attachment” section before con- necting the bottom screen to the fl oat. Turn secured assembly upside down so the top of the fl oat (logo side) is face down on the fl at surface. Place bottom screen (part 10) onto the bottom side of the fl oat. Make sure the wide opening ...

  • Page 6

    6 4400jf, 4400hjf parts included 4400jf aerating fountain (unit with cord or unit 1. With disconnect) (1) float (with two 50’ mooring ropes attached) (1) 2. 1/4-20 x 3 1/2” phillips pan head screw (4) 3. 1/4” split washers (4) 4. 1/4” (3/4” outer diameter) flat washer (4) 5. 3/8”-16 x 1-3/4” hex hea...

  • Page 7

    7 rest the fl oat on the cage top ring. Step three ensure correct alignment by twisting the fl oat gently around the motor housing until the power cord guide lines up with the cord. See diagram of bottom side of fl oat. Bolt holes power cord guide step four use one of the 1/4”-20 x 3-1/2” phillips p...

  • Page 8

    8 it will not fi t if installed from side of opening. Use the nylon cable tie included to secure the power cord to a molded hole in the fl oat to prevent cord damage if there is no strain relief on the cord. If a strain relief is present on the cord, you may disregard the nylon tie. On cords with a ...

  • Page 9

    9 attach 2 cable ties to bottom ring equally spaced 4. Clip off excess cable tie material once mesh is secured into place. Go back to assembly instructions to continue with connecting the bottom screen to the fl oat. Nozzle options note: pattern sizes listed are approximate. Varia- tions in voltage ...

  • Page 10

    10 sequoia display: the sequoia nozzle is not marked and uses the shorter 3/8” x 2.25” model height width 3400jf/hjf 7’ 4’ 4400jf/hjf 9.5’ 6’ installation instructions use the ropes to position the fountain in the desired location in the pond/lake. Anchor the ropes or secure them to the shoreline so...

  • Page 11

    11 step three follow all local and national electrical codes for this installation and consult a qualifi ed electrician or service person if needed. (for 120v installations) plug the aerator cord into the c-25 outlet labeled “unit”. If lights are included, plug the transformer cord into the c-25 out...

  • Page 12

    12 record the following data while the aerator is operating in the water under load: voltage: l1-l2 ________ l1-n _________ l2-n _________ amperage: l1 __________ l2 __________ date installed _____/_____/_____ any unauthorized modifi cations to this control panel will void the ul listing and the kas...

  • Page 13

    13 locks and re-mains depressed after pres- sure has been removed. Danger: if reset button does not pop out, if test lamp remains lit when reset button does pop out, or if the g.F.C.I. Fails to re- set properly, do not use timer! Contact a qualified service technician! Failure to use the c-25 with k...

  • Page 14

    14 c85 non-metallic wiring diagram.

  • Page 15

    15 c85 / c95 non-metallic and 3 phase control panel timer time clock setting to set the current time, turn the inner dial clockwise. Do not set the time by rotating “outer” dial. Turn the minute hand or small plastic inner dial clock- wise until the time of day on the outer dial is aligned with the ...

  • Page 16

    16 fountains will keep some amount of ice open through the winter. However, when the water is thrust into the air, it is exposed to the colder air temperatures longer and can actually make ice thicker on the pond/ lake. Storage over winter is best in a location that is out of the sun and cool, but a...

  • Page 17

    17 and determine the year of manufacture according to the serial number scheme below: sample serial # 70 01 vx 2 1725 the fi rst two digits represent the reverse of the last two digits of the year of manufacture. Example: 80 = 2008 model year. The third and fourth digits represent the week of the ye...

  • Page 18

    18 troubleshooting tips below are some helpful troubleshooting tips. If a problem occurs, please double check the assembly and installation instructions as well as the instructions for the proper control panel. More troubleshooting tips can be found at www.Kascomarine.Com “my fountain trips the grou...

  • Page 19

    19 you are noticing these symptoms, the unit should be unplugged immediately because the thermal overload will continue to turn on and off until it burns out and damages the motor. The unit should be unplugged and taken out of the water to fi nd the cause of the problem. The problem could be one of ...

  • Page 20

    20 15 17 17 13 12 2 1 11 9 8 4 7 5 6 3 16 10 18 3400j replacement parts item no. Part no. Description qty 1 241005 v tube with legs 1 2 990600 assembly, black top, 2400 1 3 390100 can, 3400, 4400 series 1 4 140312 retaining clip 4 5 840537 lock washer, 1/4" 4 6 251250 #14 x 1-1/4" long hex washer he...

  • Page 21

    21 4400j replacement parts 4400j replacement parts.

  • Page 22

    22 800 deere rd. Prescott, wi 54021 phone: 715-262-4488 - fax: 715-262-4487 www.Kascomarine.Com sales@kascomarine.Com customer repair form * important reminders * all repairs sent in must be accompanied by a copy of this completed sheet! • routine maintenance consists of checking the zinc anode regu...

  • Page 23

    23.

  • Page 24

    24 registration information please register your fountain online at: www.Kascomarine.Com (under the technical tab) also fi ll in the information below and keep for your records. Model # (ex. 3400jf)_______________________________ serial # (ex. 8001j31725)______________________________ purchase date:...