Owners manual submersible light kits models rgb3c5, rgb6c5 contents important safety. . . . Pg2 general instructions. . . . Pg2 parts included. . . . Pg2 assembly instructions. . . . Pg3 instructions for mounting led6125 and led6c11. . . . Pg5 rgb control panel installation & operating instructions....
2 thanks we at kasco marine, inc. Would like to both thank and congratulate you on your purchase of the submersible led light kit. This kit will illuminate your fountain for a beautiful display. We thank you for choosing kasco for your fountain and aeration needs and want you to be completely satisf...
3 fig 4 3. Install the 1/4” flat washer, 1/4” lock washer and 1/4” nut against the underside of the float tab as shown in figure 5. Tighten the nut until snug using the 7/16” wrench. Fig 5 flat washer lock washer 1/4” nut 4. Adjust the angle of the light as desired and tighten the two brass thumb sc...
4 instructions for mounting lights on model: 8400vfx, 8400jf, 2.3vfx, 2.3jf, 3.1jf, 3.3jf, 5.1jf, 5.3jf, 5.1vfx, 5.3vfx, 7.3jf 2. Insert the 1/4” x 5” bolt into the light bracket and extension as shown in figure 9. Place this assembly on the float bracket fig 9 3. Install the 1/4” flat washer, 1/4” ...
5 • lower float brackets (6) • 3/8” washers (3) part 1 part 2 1. Turn the unit upside down. Loosen and remove the 3/8” nuts on the three 9” bolts that are closest to the motor unit. Place 2 lower float brackets(part #1) and one 3/8” washer(part #2) on each of the 9” bolts over the bottom screen clip...
6 battery guard from the remote to activate the battery connection. 2. The rgb control box is ready to mount next to your kasco c-25, c-85, c-95 or 3phase fountain control box. (mount a minimum of 5ft from water). Using two exterior grade wood screws: one for the top and one for the bottom hanger. T...
7 2: 9 static color modes. White, red, green, blue, warm white, amber, yellow, cyan, magenta. Pressing the desired color will set the rgb controller output to that color and will remain on that color. Repeatedly pressing the color will dim the color from: 100%, 50%, 25%, 12%, 6% and cycle back to 10...
8 depending on conditions. In most cases a power washer will be sufficient if the unit and algae are still wet. Also, make sure the lens of the light fixtures is clean to ensure the brightest light possible. Fixture replacement: the led light fixtures are sealed and do not require any maintenance ot...
9 customer and billed c.O.D. Unless otherwise directed. Kasco marine also accepts visa and mastercard credit card payments. Kasco marine will call for credit card information upon completion of the estimate at the customer’s request. All other warranty and repair inquiries should be directed to kasc...
10 troubleshooting tips troubleshooting tips - the following is provided to help diagnose a probable source of trouble. It is a guideline only and may not show all causes for all problems. For additional troubleshooting help contact your local distributor or visit www.Kascomarine.Com for additional ...
11 1 6 4 3 13 7 11 12 2 8 9 10 5 items 7-10 required for small float mounting (1/2hp-1hp) items 8-12 required for large float mounting (2hp * larger) replacement parts for models: rgb3c5, rgb6c5 item no. Part number description qty. 1 347000 assembly, rgb light 1 2 345042 screw, 10-32 x 1/2 2 3 7710...
12 800 deere rd prescott, wi 54021 phone: 715‐262‐4488 fax: 715‐262‐4487 www.Kascomarine.Com sales@kascomarine.Com repair contact form kasco requires all repairs sent in must be accompanied by this form and marked to repairs attention. (ex. Attn: repairs) repairs returned should include upper pump h...
13.
14.
15.
16 registration information fill in the information below and keep for your records. Model # (ex. Rgb3c5)_______________________________ serial # (ex. 2101leda3001)____________________________ purchase date:_____________________ purchased from:___________________________________ registration date: _...
