1. DL manuals
  2. Kasda
  3. Network Router
  4. KS105
  5. User Manual

Kasda KS105 User Manual - Appendix B: Troubleshooting

Summary of KS105

  • Page 1

    Ks105 switch user manual shenzhen kasda digital technology co., ltd.

  • Page 2

    2 content chapter 1. Introduction of the product .................................................................................................................................... 3 1.1 overview of the product ...........................................................................................

  • Page 3: 1.1 Overview Of The Product

    3 chapter 1. Introduction of the product thank you for choosing the ks105 10/100mbps desktop switch. 1.1 overview of the product the ks105 architecture is the optimal solution for consumer switching needs with its support for high-performance line rate capabilities and ability to identify and priori...

  • Page 4: 2.2 Power On

    4 note: please avoid any heavy thing placed on the switch. 2.2 power on powering on the switch, it will automatically initialize and its led indicators will respond as follows: 1) all of the link/act led indicators will flash momentarily, which represents a resetting of the system. 2) the power led ...

  • Page 5: 3.2 Rear Panel

    5 3.2 rear panel figure 3-2 ks105 switch rear panel the following parts are located on the rear panel: power: lan (1-5): the power socket is where you will connect the power adapter. Please use the power adapter provided with this ks105 switch. The ks105 switch is equipped with 5 10/100mbps auto-neg...

  • Page 6: Appendix A：specifications

    6 chapter 4. Package contents the following items should be found in your box: one ks105 switch one power adapter one cd note: make sure that the box contains the above items. If any of the listed items are damaged or missing, please contact with your distributor. Appendix a：specifications standards...

  • Page 7: Appendix B: Troubleshooting

    7 appendix b: troubleshooting 1. The power led is not lit check to see if the power cord is connected to the switch properly, and make sure the power source is on. 2. The lan led is not lit when a device is connected to the corresponding port check to see if the cable connectors are firmly plugged i...