Summary of KW58191
Page 1
Kw58191 wireless adsl router user manual.
Page 2
Wireless adsl router user manual notice this document contains proprietary information protected by copyright, and this manual and all the accompanying hardware, software, and documentation are copyrighted. All rights are reserved. No part of this document may be photocopied or reproduced by mechani...
Page 3: Content
Wireless adsl router user manual content 1 overview ................................................................................................................................ 2 1.1 f eatures ..........................................................................................................
Page 4
Wireless adsl router user manual 1 overview thank you for choosing our product. The kw58191 wireless adsl router uses broadcom’s cpe solution that fully complies with adsl, adsl2，adsl2+ and ieee802.11b/g/n standards. It will provide your soho with convenient internet access. 1.1 features 1.1.1 data ...
Page 5
Wireless adsl router user manual internet control message protocol (icmp) ip static routing routing information protocol (rip, ripv2) network address translation (nat) virtual server, port forwarding dynamic host configuration protocol (dhcp) ddns simple network time protocol (sntp) ...
Page 6
Wireless adsl router user manual denial of service prevention (dos) dmz 1.1.7 management support web based gui upgrade or update via ftp/http command line interface via telnet diagnostic test firmware upgrade-able for future feature enhancement 1.1.8 operating system support windows ...
Page 7
Wireless adsl router user manual 1.3 system requirements before using this router, verify that you meet the following requirements: subscription for adsl service. Your adsl service provider should provide you with at least one valid ip address (static assignment or dynamic assignment via dial-up c...
Page 8
Wireless adsl router user manual 2 hardware description front panel led color function power green on: power on off: no power lan1 green on: lan link established and active via lan port blinking: adsl data activity occurs off: no lan link via lan port wlan green on: the wireless module is ready and ...
Page 9
Wireless adsl router user manual rear panel port function dsl connect the device to an adsl telephone jack or splitter using a rj-11 telephone cable eth connect the device to user’s pc's ethernet port, or to the uplink port on user’s hub/switch, using a rj-45 cable reset system reset or reset to fac...
Page 10: 3 Hardware Installation
Wireless adsl router user manual 3 hardware installation this chapter shows user how to connect router. Meanwhile, it introduces the appropriate environment for the router and installation instructions. 1. Using a telephone line to connect the dsl port of router to the modem port of the splitter , a...
Page 11
Wireless adsl router user manual 4 pc configuration guide 4.1 local pc configuration in windows 95, 98, me, xp 1. In the windows task bar, click the “start” button, point to “settings”, and then click “control panel”. 2. Double- click the “network” icon. 3. On the “configuration” tab, select the tcp...
Page 12
Wireless adsl router user manual 4.3 local pc configuration in windows vista 1. Go to start. Click on network. 2. Then click on network and sharing center at the top bar. 3. When the network and sharing center window pops up, select and click on manage network connections on the left window column. ...
Page 13
Wireless adsl router user manual 5 web-based management guide in order to use the web-based management software it will be necessary to use a computer that occupies the same subnet as the router. The simplest way to do this for many users will be to use dhcp server that is enabled by default on the ...
Page 14
Wireless adsl router user manual from setup, click wan, configure the parameters for the channel operation modes of your adsl router. 5.2.1 pppoe(ppp over ethernet) pppoe (point to point protocol over ethernet) provides access control and billing functionality in a manner similar to dial-up services...
Page 15
Wireless adsl router user manual item description vpi/vci enter the pvc that your isp gives you. Enable napt napt extends the notion of nat one step further by also translating the transport identifier (tcp and udp port numbers, icmp query identifiers). This allows the transport identifiers of a num...
Page 16
Wireless adsl router user manual 5.2.2 pppoa(ppp over atm) pppoa stands for point to point protocol over atm adaptation layer 5 (aal5). A pppoa connection functions like a dial-up internet connection. The router encapsulates the ppp session based on rfc1483 and sends it through an atm pvc (permanent...
Page 17
Wireless adsl router user manual item description vpi/vci enter the pvc that your isp gives you. Enable napt napt extends the notion of nat one step further by also translating the transport identifier (eg tcp and udp port numbers, icmp query identifiers). This allows the transport identifiers of a ...
Page 18
Wireless adsl router user manual 5.2.3 bridged with bridging the router has a static ip address for connection. The router passes traffic through to another device (a computer or router for example) that handles authenticating with the isp. Enter vpi and vci according to your local region and select...
Page 19
Wireless adsl router user manual 5.2.4 lan settings from lan, configure the dsl router’s ip address and subnet mask for lan interface. In this page, you can use dhcp (dynamic host configuration protocol) to control the assignment of ip addresses on your local network (lan only).Kw58191 support ipv4 ...
Page 20
Wireless adsl router user manual item description ip address this is the ip address that other devices on your local network will use to connect to the modem. The default is 192.168.1.1. Subnet mask this defines the size of your network. The default is 255.255.255.0. Secondary ip select this option ...
Page 21
Wireless adsl router user manual 5.2.4.1 ipv6 lan interface from setup→lan →lan ipv6, configure the dsl router’s ipv6 address for lan interface..
Page 22
Wireless adsl router user manual item description global address this is the ipv6 address that other devices on your local network will use to connect to the modem. Ra setting the ipv6 ra feature provides support for allowing the network administrator to block or reject unwanted or rogue router adve...
Page 23
Wireless adsl router user manual 5.3 wlan setting 5.3.1 basic option description enable wireless a check box that enables or disables the wireless lan interfaces. The default is to enable wireless communications. Band this is the range of frequencies the gateway will use to communicate with user’s w...
Page 24
Wireless adsl router user manual isolation network name (ssid) enter a name for user’s wireless network here. Ssid stands for service set identifier. This name must be between 1 and 32 characters long. All wireless clients must either detect the gateway or be configured with the correct ssid to acce...
Page 25
Wireless adsl router user manual note: after making any changes, click apply to save. Warning: the settings shown above are default settings. Changes made to these items can cause wireless communication problems. Field description fragmentatio n threshold a threshold, specified in bytes, that determ...
Page 26
Wireless adsl router user manual xpr ess™ technology xpress™ technology is a feature in which two of our devices can communicate with each other at twice the normal rate. 54g+ is a technology that achieves higher throughput with frame-bursting. With 54g+ enabled, aggregate throughput (the sum of the...
Page 27
Wireless adsl router user manual 3.Enable wps as below. 4. Set start pbc and click save/changes. 5.Now you can use a wireless adaptor with wps function and the wps button to connect to access the internet. 6. To configure security features for the wireless interface, please open security item from w...
Page 28
Wireless adsl router user manual secure user’s data while connecting to networks. There are four selections including open, shared, 802.1x,wpa, wpa-psk, wpa2, wpa2-psk, mixed wpa-wpa2, mixed wpa-wpa2-psk. Different item leads different web page settings. Please read the following information careful...
Page 29
Wireless adsl router user manual encryption method that is not as hard to break as the more-recent wpa. 802.1x — in 802.1x (also known as radius), a separate machine called an authentication server receives a user id and password. It grants or denies access based on whether the id and password match...
Page 30
Wireless adsl router user manual 5.4 management 5.4.1 tr069 wan management protocol (tr-069) allows a auto-configuration server (acs) to perform auto-configuration, provision, collection, and diagnostics to this device. Select configure tr-069 from advanced->cwmp. Url: url for the cpe to connect to ...
Page 31
Wireless adsl router user manual making a connection to the acs using the cpe wan management protocol. This username is used only for authentication of the cpe. Connection request password: password used to authenticate the cpe when making a connection to the acs using the cpe wan management protoco...
Page 32
Wireless adsl router user manual 2. Enable it and select group1 as below. 3. Set as below..
Page 33
Wireless adsl router user manual 4. Click apply and you’ll see the following screen. 5. Click save, now you can use lan1 interface for iptv and other ethernet interface for internet. Note: if you want to cancel all modification that you do on the router, please select from “admincommit/rebootfacto...
Page 34
Wireless adsl router user manual appendix frequent asked questions q: none of the leds are on when you power on the adsl router? A: please make sure what you use is the power adaptor attached with the adsl router package，and check the connection between the ac power and adsl router. Q: dsl led does ...
Page 35
Wireless adsl router user manual q: pc cannot browse internet web page? A: please make sure dns server appointed to the pc is correct. You can use ping application program to test whether the pc can connect to the dns server of the adsl operator. Q: initialization of the pvc connection failed? A: be...