KAT Ka1 User Manual

Summary of Ka1

  • Page 1

    Drum amplifier user manual ka1 manual_v2.Indd 1 1/17/13 11:49 am.

  • Page 2: Fcc Statements

    Fcc statements 1. Caution: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. Note. This equipment has been tested and found to comply with the limits for a class b digital device, pursuant...

  • Page 3

    Congratulations on your purchase of the kat ka1 this ka1 amplifier was built from the ground up to offer world-class tone, useful features and reliable performance. Inside this manual, you’ll find valuable information about the amp’s controls and specifications. Being familiar with its features will...

  • Page 4

    Important safety instructions danger exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The u.S. Government’...

  • Page 5

    Important safety instructions french danger l‘exposition a des niveaux eleves de bruit peut provoquer une perte permanente de l’audition, chaque organisme humain reagit differemment quant a la perte de l’audition, mais quasiment tout le monde subit une diminution de i’acuite auditive lors d’une expo...

  • Page 6

    Inputs 1 and 2: these are ¼-inch input jacks for connecting your drum module to the amplifier. They use the same volume control, labeled 1-2. Aux input: this ¼-inch jack is used for connecting any pre-eq audio source. The volume of the aux input is controlled by the aux volume control. If using a st...

  • Page 7

    Rear panel 1 3 2 1 3 2 ac power cord receptacle: insert the ac cord (provided) firmly into the ac connector. Note: replace the ac power cord if protective jacket is damaged or ground pin is damaged or removed. Note: to prevent an electrical hazard, do not replace fuse without using the fuse carriage...

  • Page 8

    Ka1 specifications output power (rms 1%) 50w/8 Ω × 1 internal speakers 500mw/32 Ω × 2 output to headphones (mono mix) frequency response 20-20khz actual response is tailored for accurate acoustic response for electronic drums hum and noise -55 dbv all controls turned down -50 dbv all controls turned...