Kathrein UFS 933 Quick Start Manual - page 7
Explanation of symbols and safety instructions
6 of 40
ATTENTION
Material damage due to:
Incorrect supply voltage!
► Operate the unit only at the specified mains voltage. It is stated at the
back of the unit or on the external power supply unit.
Incorrectly earthed antenna system!
► Earth the antenna system in accordance with regulations or connect an
equipotential bonding conductor.
► Comply with EN 60728/11 and, where applicable, with national regula-
tions.
Overheating!
► Do not cover or block the ventilation slots or the fan of the unit by, for
example, other objects, magazines, table cloths, clothing or curtains.
► Do not place any objects on top of the unit.
► Do not place naked flames on the unit, e.g. candles.
► Do not expose the unit to direct sunlight.
Long periods of absence or storms!
► If you are going to be absent for a long time or if there is a storm,
always switch off the receiver by pressing the ON/OFF switch.
► Pull the plug out of the mains socket to completely disconnect the unit
from the mains.
► Disconnect other devices connected with the unit from the mains.
Incorrect connections!
► Connect the unit as it is described in the enclosed instructions for use.
ATTENTION
Loss of data and software corruption due to the receiver being dis-
connected from the mains whilst in use!
► Always switch the receiver into stand-by mode by pressing the stand-
by button on the remote control before disconnecting it from the
mains.
➯ Altered and new data are saved.