Katsuragawa electric co., ltd. Digital printer kip 7900 user’s manual version a.1 july 16, 2009 -please read this user’s manual before using the printer. -please keep this user’s manual for future reference..
(1) thank you for purchasing the kip 7900. This user's manual contains functional and operational explanations for the kip 7900. Please read this user's manual carefully before using the printer. Please keep this user's manual for future reference. 1. When this machine is installed in north america....
Chapter 1 before use 1-2 1. 1 installation requirements the following conditions are required for installation of the equipment. 1. Power source should be rated as follows. 220v - 240v plus 6% or minus 10%, 50/60hz, 20a or higher 2. The equipment must be on an exclusive circuit. 3. The outlet must b...
Chapter 1 before use 1-5 1. 4 specifications subject specification model kip 7900 configuration console printing method electro photography photoconductor organic photoconductive drum print speed 160mm per second (inch) e: 7 sheets/min d landscape: 12 sheets/min (metric) a0: 7 sheets/min a1 landscap...
Chapter 1 before use 1-6 storage of consumables (media) wrap the media surely to shut out the humidity. (toner cartridge) keep the toner cartridge away from the direct sunlight, and store it in the condition of 0 to 35 degrees centigrade and 10 to 85% rh. Note the above specifications are subject to...
Chapter 2 basic operations 2-2 2. 1 turning on kip 7900 1 . Plug the printer into an exclusive wall outlet. 2. There is power switch on the right-front of the printer. Press “ ” side to turn on the printer. Warning (1) do not handle the power plug with wet hands, or you may receive an electrical sho...
Chapter 2 basic operations 2-3 3. The user interface (ui) starts operating, and displays ui screen in one minute. Ready indicator on the ui will flash during warming up. The ui screen may vary depending on your system configuration. (shown with available options) 4. When ready indicator stops flashi...
Chapter 2 basic operations 2-4 2. 2 turning off kip 7900 1. Press “ ” side on the power switch to turn off the printer. Caution (1) kip 7900 and the ui look to be shut down when you turn off kip 7900. However, the embedded controller is still operating in approximately 2 minutes after power switch o...
Chapter 2 basic operations 2-18 2. 6 canceling sleep mode the kip 7900 has two sleep modes to reduce the power consumption. The kip 7900 will enter sleep mode after a certain period of inactivity. In the default setting; • warm sleep mode will start after a 15 minute of inactivity in order to reduce...
Chapter 2 basic operations 2-19 2. 7 dehumidifying roll media if the roll paper is extremely humid, it may cause poor prints. You will experience most likely “creasing” and “voids”. Turn on the dehumidify heater if the room air has too much humidity (65% or higher) to prevent the above kinds of prin...
Chapter 2 basic operations 2-20 “dehumidify heater switch” is located on the left-rear side of the machine. Press “h” to turn on the dehumidify heater. Note (1) there are several dehumidifying settings which can be set by service personnel. When these settings are determined, the dehumidifier functi...
