Kawai CN27 Service Manual - page 27
P27 Software
CN27
● MIDIによる Flash ROM(MPU) プログラムの書換方法
How to rewrite the Flash ROM program by MIDI.
1) 電源をOFFする。
Turn the power switch off.
2) MIDIケーブルで本体にシーケンサを接続する。
Connect sequencer by MIDI cable.
3) [CONCERT MAGIC]、[LESSON]、[PLAY/STOP]スイッチを押しながら電源を投入する。
Turn on the power switch while pressing the [CONCERT MAGIC], [LESSON] and [PLAY/STOP] buttons
simultaneosly.
4) シーケンサで“KP773Fsys.mid”をプレイする。
Play "KP773F.mid" by MIDI sequencer.
● 仕向地確認/変更方法
How to identify / change the destination.
1) [CONCERT MAGIC]、[PLAY STOP]、[METRONOME]のボタンを押しながら電源オン。
Power ON while holding [CONCERT MAGIC], [PLAY STOP], [METRONOME] buttons.
以下のようにLEDパネルに仕向が表示される。
Destination is displaying on LED Panel as below.
For Japanese
[JP]
For US/AU
[US]
For GE230/CD/CG/BIS (Enabled Bluetooth)
[UKb]
For GE120/KA/HV/AR (Enabled Bluetooth)
[EUb]
For GE230/CD/CG/BIS (Disabled Bluetooth)
[UK]
For GE120/KA/HV/AR (Disabled Bluetooth)
[EU]
For CV
[CV]
仕向を変更しなければ、仕向表示を確認し、電源OFFする。
If you don't change a destination, identify the display for a destination, then turn the power off.
2) 仕向を変更する場合、A0(最低鍵)とC2(最低鍵から16番目)を押しながら以下の鍵を押す。
If you change a destination, press and hold the A0 (the lowest key on the keyboard) and the C2
(16th from the lowest key), and press the following key.
For Japanese
D#2
(19th from lowest key)
For US/AU
G#2
(24th from lowest key)
For GE230/CD/CG/BIS (Enabled Bluetooth)
F#2
(22th from lowest key)
For GE120/KA/HV/AR (Enabled Bluetooth)
A#2
(26th from lowest key)
For GE230/CD/CG/BIS (Disabled Bluetooth)
F2
(21th from lowest key)
For GE120/KA/HV/AR (Disabled Bluetooth)
A2
(25th from lowest key)
For CV
C#2
(17th from lowest key)
注意 Notice
Flash ROM の書き換えを途中で止めることはできません。
電源を切ると復帰できなくなる場合があります。必ず最後まで書き換えてください。
You can not stop rewriting operation in half way.
Do not turn the power off in the operation.
You have to complete the operation.