Kawasaki JT1500D9F - 2009 Installation Manual

Summary of JT1500D9F - 2009

  • Page 1

    Viking range corporation 111 front street greenwood, mississippi 38930 usa (662) 455-1200 for product information, call 1-888-viking1 (845-4641) or visit the viking web site at vikingrange.Com f20543b en (062209j) ® viking installation guide professional freestanding gas & gas self-clean sealed burn...

  • Page 2

    Important– read and follow! 3 2 table of contents • before beginning, please read these instructions completely and carefully. • do not remove permanently affixed labels, warnings, or plates from product. This may void the warranty. • all local and national codes and ordinances must be observed. Ins...

  • Page 3

    Important– read and follow! 5 4 danger gas leak hazard to avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer’s instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • do not use an...

  • Page 4

    Dimensions 7 dimensions 6 35-7 /8” (91.1 cm ) m in. To 37” (94.0 cm ) m ax. 1” (2.5 cm ) 29-7 /8” (75.9 cm ) 35-7 /8” (91.1 cm ) 47-7 /8” (121 .6 c m) 60” (152 .4 c m) note: unit shown with standard island trim. Note: 30” vgsc self-clean ranges are 3/8” (1 cm) deeper than 30” vgcc non self-clean ran...

  • Page 5

    Specifications 9 specifications 8 minimum clearances from adjacent combustible construction: below cooking surface (36” [91.4 cm] and below) • sides - 0” • top grate support - 36” (91.4 cm) above cooking surface (above 36” [91.4 cm]) • sides - 6” (15.2 cm) • within 6” (15.2 cm) side clearance, wall ...

  • Page 6

    42 ” m in. (10 6.7 cm ) 13 ” m ax . ( 33 .0 cm ) 6” min . (15.2 cm ) 18 ” m in. (45 .7 cm ) 3/ 8” (0. 95 cm ) 36 ” (91 .4 cm ) 29-7 /8” (75.9 cm ) clearance dimensions (wood/composite overlay) 11 clearance dimensions (proximity to cabinets) 10 • this range may be installed directly adjacent to exist...

  • Page 7

    13 electrical & gas requirements 12 electrical requirements check your national and local codes regarding this unit. This range requires 120vac/60 hz; 4 ft. (121.9 cm), 3-wire cord with grounded 3-prong plug attached to unit. See “electrical connection” section for grounding instructions. Must be fu...

  • Page 8

    15 14 general information read and follow all warning and caution information when installing this appliance. • all openings in the wall behind the appliance and in the floor under the appliance must be sealed. • do not obstruct the flow of combustion and ventilation air. Moving, handling, and unpac...

  • Page 9

    16 17 1 1 1 2 3 2 legs are packed in styrofoam top pack. Note: legs should be installed near to where appliance is to be used, as they are not secure for long transit. Note: it is strongly recommended that a pallet or lift jack be used rather than tilting. Raise unit about a foot. Unscrew temporary ...

  • Page 10

    19 18 1 me asu rem ent (a) measur ement (a) me asu rem ent (a) me as ure me nt (a ) measur ement (a) +1 /4 ” +1/4” (.6 4 c m) (.64 cm) me as ure me nt (a ) +1 /4 ” ( .64 cm ) 22-1 /4” 22-1/4” (56.5 cm ) (56.5 cm) 22-1 /4” (56.5 cm ) 2 measure from floor to bottom of the anit-tip opening located on t...

  • Page 11

    20 21 1 2 reattach door to range. Open door completely. Reattach hinge trim. 3 4 remove pins from hole in hinges. Close door. 5 if the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32” hex head allen wrench. ...

  • Page 12

    23 22 only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact viking range corporation, 1-888-viking1 (845-4641), for the nearest service parts distributor in your area or write to: viking range corpora...