Kayakpro K1 SpeedStroke Assembly - Rope Bungee Paddle
what you will need before beginning
2 sets of ropes (the other 2 ropes in the package
are spares- as is the additional bungee)
3 peices of the paddle shaft
The smallest Allen wrench in the set provided.
Please ensure that during transit the bungee cord
on this central roller is still located on the roller
wheel here and has not slipped onto the axle.
(see image above)
The following instructions from this point forward,
assume the internal bungee arrangement is in place
within the body of the SpeedStroke at arrival. If this
is not the case, please do not hesitate to contact us
in order to assist you further.
Step 1:
On one side of the SpeedStroke, run the bungee cord
around the roller on the back of the machine, under the seat. It
should go from the top of the roller to the bottom. (See image.)
PLEASE NOTE:
You may need to remove the aluminum anti-
twist connector from the bungee, to install the rope / bungee
system. Run bungee around rear roller (again, from top to bot-
tom), and then reattach anti-twist unit by tightening recessed
screw fully. (See image.) The anti twist connector has different
recessed screws for the rope and for the bungee end- If one
screw is found to be protruding please rotate the Anti-twist
connector and re-attach.
Step 2:
Repeat on the other side.
pre-instruction
Once the main structure of the SpeedStroke is
assembled, it should remain “upright.” Do not
place the machine on its side or upside down
during final assembly.
www.kayakpro.com
010
rope bungee paddle
shaft conf guration
i
rope bungee paddle
instructions
steps 1 & 2
bungee
rope