Kaysun KAE-26 DN7 Technical Manual - page 30
Manual is about: PRODIGY 3D
of
64
PRODIGY Technical Manual
30
6.5
How to Remove the PCB
Step1:
Press A to remove the terminal cover.
Step2:
Remove screw B to remove the cover of the
electronic control box .
Step3:
Then you can remove the PCB.
Note:
It is not necessary to remove the panel to
remove the PCB. in order to show clearly inside,
these pictures are without panel.
6.6
How to Remove the Electrical control
box
Step1:
Remove screw A,B,C, pull out the coil temp.
sensor D from the sensor holders.
Step2:
pull out the Electrical control box.
Note:
It is not necessary to remove the panel to
remove the Electrical control box, in order to
show clearly inside, these pictures are without
panel.