1. DL manuals
  2. KaZAM
  3. Bicycle
  4. blinki
  5. Owner's Manual

KaZAM blinki Owner's Manual

Manual is about: balance bike

Summary of blinki

  • Page 1

    Owner’s manual please read and fully understand this manual before operation this manual contains important safety, assembly operation and maintenance information. Save this manual for future reference..

  • Page 2: Owner’S Manual Index

    2 owner’s manual index your bike bicycle identification record ................................................................. 3 fitting the rider to the bicycle ............................................................... 3 warning and safety information ...........................................

  • Page 3

    3 bicycle identification record note : this information can only be found on the bicycle itself, and is not available from kazam each bicycle has a serial number placed on the frame. The serial number can be found on a sticker on the bottom of the frame as shown (1). Write this number below to keep ...

  • Page 4

    4 warning and safety information this symbol is important. See the word “caution” or “warning” which follows it. The word “caution” is used before mechanical instructions. If these instructions are not obeyed, mechanical damage or failure of the bicycle can occur. The word “warning” is used before p...

  • Page 5

    5 rules of the road ‐ continued use extra caution in wet weather conditions: ride slowly and use caution on damp surfaces because the tires will slide more easily. Avoid the hazards listed below to prevent loss of control or damage to your wheels: be aware of drain grates, soft road edges, gravel or...

  • Page 6

    6 fig 01.

  • Page 7

    No. Descrip tio n no. Descrip tio n 1 frame 15 re ar li gh t a ssembly 2 fo rk 16 re ar li gh t g asket 3 handlebar 17 re ar batte rie s ( x3 ) not include d 4 grips (x 2) 18 re ar ba tt ery clip 5 stem 19 se at p in 7 se at 20 wheel r etai ne r (x4) 9 se at po st 21 wheel nu t ( x4) 10 head set 22 ...

  • Page 8

    8 introduction this owner’s manual is made for several different bicycles: use the index page to locate specific sections of this manual. Some illustrations may vary slightly from the actual product. Completely follow instructions. If your bicycle includes any parts that are not described in this man...

  • Page 9

    9 assemble the front wheel to the fork 1. If the axel nuts (21) are already attached to the front wheel axel, begin by removing them with an open end wrench or adjustable wrench. 2. Place the wheel into the front fork (2) (fig 02) 3. Install wheel retainers (20) making sure the tabs are in the fork ...

  • Page 10

    10 handlebar and stem installation warning: to prevent loss of control and steering system damage, the “min-insert” (minimum insertion) mark (a) on the stem must be below the top of the locknut (b). Note: remove plastic cap from the end of the stem (5). 1. Insert the stem (5) into the fork (fig 03)....

  • Page 11

    11 testing stem and handlebar tightness to test the tightness of the handlebar/stem: straddle the front wheel between your legs. Attempt to turn the front wheel by turning the handlebar. If the handlebar and stem turn without turning the front wheel, realign the stem with the wheel and tighten the s...

  • Page 12

    12 light insert installation warning: some models of this bicycle utilize flashing lights. Certain people may experience epileptic seizures when viewing flashing lights or patterns. If your child has an epileptic condition please consult your physician before using our bicycle. 1. Insert three aaa b...

  • Page 13

    13 light insert installation 1. Insert three aaa batteries into rear battery tray (18) 2. Insert rear battery tray (18) into rear light insert (15) 3. Place rear silicone gasket (16) over the front insert slot in frame. 4. Insert rear light insert into slot. (fig 01) 5. Securely fasten with supplied...

  • Page 14

    14 seat installation caution: if you accidentally drop the seat post into the seat tube, it may be difficult to remove. Seat adjustment: remove seat pin (19) (fig 06) move seat and seat post (9) to desired position align holes in frame and seat post reinsert seat pin (19) fig 06.

  • Page 15

    15 repair and service warning: failure to inspect the bicycle frequently, and to make repairs or adjustments as necessary can result in injury to the rider or to others. Make sure all parts are adjusted and assembled correctly as written in this manual and any “special instructions” if included. Rep...

  • Page 16

    16 tires maintenance: check the tire inflation pressure frequently as all tires lose air slowly over time. Keep weight of bicycle off the tires for extended storage. Do not use compressed air filler points at petrol stations to inflate the inner tubes. This can cause the bicycle tires to overinflate ...

  • Page 17

    17 limited warranty this warranty extends only to the original buyer who must produce proof of purchase in order to validate any claim. This warranty is not transferable. This limited warranty covers all parts of the bicycle to be free of defects in workmanship and materials. This warranty is effecti...

  • Page 18: Warranty Duration:

    18 limited warranty warranty duration: the frame is warranted for one year from the date of purchase when properly assembled and used in a normal manner. Kazam will replace the frame at no charge, should it fail when the cycle has been used in a normal manner, and determined by our inspection. Kazam...

  • Page 19: Warning:

    19 warning: always wear your helmet when riding this product!.