KaZAM swoop balance Assembly Instructions Manual

Summary of swoop balance

  • Page 1

    1 kazam swoop balance bike assembly this instruction booklet contains important safety information. Please read and keep for future reference. For service assistance call 757.452.3945 monday - friday 9:00 a.M. To 5:00 p.M. Eastern standard time congratulations on the purchase of your new swoop balan...

  • Page 2

    2 avoid riding in wet conditions. Responsibility of the owner! Important: reading and following the information and instructions in this manual are essential to your ability to ride safely. 1. It is the responsibility of the owner or in the case of a younger rider the parents of the rider to be cert...

  • Page 3

    3 maintenance on your bike, it is vital that you promptly consult a local bike mechanic for professional assistance and support. Warning: as with all mechanical components, the bicycle is subjected to wear and high stresses. Different materials and components may react to wear or stress fatigue in d...

  • Page 4

    4 table of content parts identification graphics.........................5 before riding.................................................8 assembly instructions...................................9 maintenance.................................................13 warranty...................................

  • Page 5

    5 important: use this diagram when reading this manual to help you understand directions and instructions..

  • Page 6

    6 rules of the road in the interest of safe cycling, make sure you read and understand the owner’s manual. In this manual you will find danger, warning, caution, important, and note or notice. These are important signal words telling you to pay special attention to that text as rider safety is invol...

  • Page 7

    7 5. Caution: a bicycle rider’s best defense against accidents is to be alert to road conditions and traffic in the area. Do not wear anything that restricts your vision or your hearing. 6. When riding, always wear a cpsc approved bike helmet. 7. Obey all traffic regulations. Most traffic regulation...

  • Page 8

    8 before riding: your new bicycle was assembled and tuned in the factory and then partially disassembled for shipping. The following instructions will enable you to prepare your bicycle for years of enjoyable cycling. For more details on inspection, lubrication, maintenance and adjustment of any are...

  • Page 9

    9 assembling your bike preparation: it is important that you read this owner’s manual before you start to assemble your bicycle. We recommend that you consult a professional bicycle mechanic if you have doubts or concerns as to your ability to properly assemble, repair, or maintain your bicycle. Rem...

  • Page 10

    10 correct saddle height should not allow leg strain from over-extension, and the hips should not rock from side to side when coasting. The correct saddle height will allow the knee to be slightly bent. To obtain maximum comfort, the rider should not over extend his or her reach when riding. There s...

  • Page 11

    11 3. Place a drop of oil under the head of the expander bolt. Tighten the expander bolt just enough to hold the stem in place. 4. Raise or lower the handlebar stem until you have reached the desired height for your child and then position the handlebar so it is perpendicular (90 degrees) to the fro...

  • Page 12

    12 warning: never inflate a tire beyond the maximum pressure marked on the tire’s sidewall. Exceeding the recommended maximum pressure may blow the tire off of the rim, which could cause damage to the bike and injury to the rider and others. The best way to inflate a bicycle tire to the correct pres...

  • Page 13

    13 caution: be sure the reflector is vertical to the ground. If the reflector is aimed up or down, oncoming headlights may not reflect properly in the reflector. Maintenance & repair correct routine maintenance of your new bike will ensure a longer life for your bike and a safer ride for you. Every ...

  • Page 14

    14 caution: use a hand or foot pump to inflate tires. Never inflate tires with an air compressor at a gas station. This can cause the tubes to over inflate and blowout. Bead seating: when inflating or refitting the tire, make sure that the bead is properly seated in the rim. Tread: check that the tr...

  • Page 15

    15 warranty this warranty extends only to the original retail purchaser, who must produce proof of purchase in order to validate any claim. This warranty is not transferable to anyone else. What does this warranty cover? This limited warranty covers all parts of the bicycle to be free of defects in ...