KBC FTL1-S2-MSC User Manual - page 7
Manual-FTL1-Rev1009.pdf
Page 7 of
9
www.kbcnetworks.com
Copyright © KBC Networks Ltd.
•
AC:
There is no difference between +/-, the power supply can be connected into the
device directly.
Transceiver Right View
Connectors:
TX: Fiber Optic ST( Transmit )
RX: Fiber Optic ST( Receive )
LAN: LAN RJ45
Beside the Ethernet RJ45, there are two LEDs:
The green LED: Ethernet Link.
Flashing if the link is in OK
The yellow LED: Fiber Link. Flashing if the link is in OK
2.3 Caution
•
Switch off all power supply before installation.
•
Ensure fiber is properly aligned to the receiving connector. Avoid forcing in the fiber.
•
The FTL1-S2-MSC Series is an auto-sensing device.