Kchibo kk-c55 User Manual - page 3
2.
Press the Direct Frequency Input button(7) again to confirm.
Examples :
1.
FM 99.30MHz : Press Band Selector (9) to switch to FM. Press (7) button ……Press
9-9-3……Press (7) button to confirm.
2.
SW 6.84MHz : Press Band Selector (9) to switch to SW. Press (7) button ….. Press 6-8-4…..Press
(7) button to confirm
Memory Presets :
1.
Use auto, manual or direct frequency input to locate the station.
2.
Press the MEMORY button (3) , the LCD indicator will blink.
3.
Press 0-9 (CH1-CH10) within 5 seconds to select the channel. Press the Memory button (3) again
to confirm.
4.
Under the radio mode, press the numeric button to call for stored station.
Note : You can store up to 10 stations for each band (FM, SCH,MW, SW) , When new frequency is
selected , the old memory will be erased.
Mono/Stereo/Megabass :
Stereo can only be operated when the earphone is plugged in (19). Press the Mono/Stereo (6) to switch
to stereo reception. Long press for 5 seconds the Mono/Stereo (6) to turn on the megabass.
Use of Antenna :
1.
AM : The built-in magnetic antenna inside the radio is used. Rotate body to get best reception.
2.
FM : Extend the antenna. Try different angles to get the best reception
3.
SW : Extend the antenna. Make the antenna vertical.
4.
You can improve the radio reception by using the extension wiring antenna.
Time setting :
The clock uses 24 hour system.
1.
When batteries are is installed, the “0:00” will display.
2.
Press the Time Set (3) button. The hour digit will blink. Press the + (16) or – (14) button to set the
hour . Long press for fast moving.
3.
Press the Time Set (3) button again. The minute digit will blink. Press the + (16) or – (14) button to
set the minute.
4.
Under the radio mode, you can press the mode button (4) to check the time , alarm time 1 and 2. It
will resume to frequency display after 10 seconds.
Alarm Time Set :