KDAR HM2000 Operator's Manual - Set Up
KDAR Company
5
Set Up
Engine Preparation
Engine Oil
NOTE: Engine oil is a major factor affecting
the performance and service life of this genera-
tor. Non-detergent and 2-stroke engine oils
WILL damage the engine and are not recom-
mended.
1. Use 4 stroke oil, or an equivalent high deter-
gent, premium quality motor oil certified to
meet or exceed U.S. automobile manufac-
turer’s requirements for Service Classification
SG, SF/CC, CD. This designation will be on
the motor oil container.
2. SAE 10W-30 is recommended for general, all-
temperature use. See chart for appropriate
weights for your area.
3. Locate the oil filler cap and remove.
Oil Filler
Cap
4. Fill with .63 quarts (.6 Li-
ters) of motor oil.
5. Confirm proper fill by re-
placing the dip stick and
checking the oil level.
Fueling the Engine
WARNING
•
Gasoline is extremely flammable and is
explosive under certain conditions.
•
Fuel and refuel in a well ventilated
area with the engine stopped.
•
Do not smoke or allow flames or
sparks in the area where the engine is
being refueled or where gasoline is
stored.
•
Do not over fill the tank (there should
be no fuel in the filler neck).
•
After refueling, make sure the tank
cap is closed properly and securely.
•
Be careful not to spill fuel when fueling
or refueling. Spilled fuel or fuel vapor
may ignite.
•
If fuel is spilled make sure the area is
dry and free of fumes before starting
the engine.
•
Avoid fuel contact with the skin or
breathing vapors for a prolonged pe-
riod.
•
KEEP FUEL OUT OF THE REACH
OF CHILDREN.
1. Unleaded gasoline with a octane rating of 86 or
higher is recommended because it produces
fewer engine and spark plug deposits and ex-
tends the exhaust system life.
2. Remove tank cap and fill tank.
3. Do not fill tank above the shoulder of the fuel
strainer.
Strainer
Shoulder