Keating Of Chicago Flexible Tubing to Hard Piping 055173 Service Instructions

S E R V I C E   I N S T R U C T I O N S

www.keatingofchicago.com

1-800-KEATI NG

Part # 037670

FLEXIBLE TUBING to HARD PIPING INSTALLATION

INSTRUCTIONS - for MOTOR/PUMP PART# 055173

Notes:

1. Drain and clean all oil from filter tub assembly. Remove filter tub assembly 

from filter cart frame assembly. This assembly will be turned over (upside 

down), for replacement of parts and adjustment to mating part on motor 

mount housing assembly.

2. Remove pull rod and set aside; this part will be used later.

3. Loosen compression fitting at pump output. Do not remove 90° 

fitting from pump.

4. Remove (4) bolts holding bracket SE coupler. This assembly will be 

replaced with new parts in kit. The bracket and flex tubing with quick 

connect are to be discarded.

5. Inspect 90° compression fitting on the pump as shown in View A – A. If the 

fitting is not on center line of the radius on the pump mount housing 

assembly as shown, use a #23 or #24 drill to remove pump housing 

covers (2) as shown in view A – A, to gain easier access to the top bolts 

holding the motor/pump. Loosen (4) bolts on motor/pump to center 90° 

fitting as best as possible. These covers will be re-assembled with parts 

in the kit. After adjustments are made to the motor/pump to center 90º 

compression fitting as shown in view A – A, tighten the (4) bolts for the 

motor/pump.

Motor/Pump

Housing Covers

See Note #5

(2X)

Motor/Pump

Housing Assembly

90° Compression

Fitting See Notes

#3 and #5

View “A – A”

Pull Rod 

See Note #2 Compression Fitting

See Note #3

Bracket SE Coupler

See Note #4

Filter Cart Frame Assembly

Filter Tub Assembly in Unlocked Position

Filter Tub Assembly 

See Note #1

Use these Service

Instructions for the

following Kit part #’s:

057117

SE14

057118

SE18

057119

SE20

057120

SE24

Caution:

Make Sure Saftey Glasses are Worn

part# 037670

p a g e   1

h a r d P i p i n g 0 57 1 2 2 . q x d

1 0 / 0 9