Keating Of Chicago TOP-SIDE PRE-2005 series User Manual - page 8
|
keatingofchicago.com
THE TOP-SIDE™ COOKING HEAD AND GRIDDLE
PLATE ARE HOT - USE PROPER CARE WHEN
CHANGING THE COOKING SHEETS.
LEVELING OF COOKING HEAD(S)
The Cooking Heads were leveled at the factory.
NOTE: For best results, level griddle before checking.
Adjust legs or stand casters to level griddle.
REMOVAL OF COOKING HEAD
NOTE: To identify parts, refer to page 10.
1. Turn off griddle and disconnect Top-Side™ Cooker
electric power.
2. Remove the cooking sheet by lifting off cooking
sheet mounting clips.
3. Place a layer of soft cloth and then a layer of
cardboard onto griddle plate under cooking head to
protect Miraclean® surface.
4. Raise cooking head completely to release tension
on cooking head support pin. Remove support pin
and its cotter pin and carefully lower cooking head to
protected griddle surface.
The cooking head is not supported after the cook-
ing head support pin has been removed. If dropped
the weight of the cooking head when unsupported
will cause damage to the griddle surface or injury to
personnel.
5. Do not turn the support pin in either direction.
6. To reattach the cooking head to the ram lift arm,
raise cooking head completely and replace cooking
head support pin. Insert a new stainless steel cotter
pin to secure support pin, holding support pin to
keep it from spinning.
7. Replace cooking sheet. See - “Installing a Cooking
Sheet”.
SERVICE DIAGNOSIS
A properly adjusted Keating Top-Side™ Cooker, with
no load, will cycle “ON” approximately every 5-1/2 to
6-1/2 minutes. Each cycle will last 40 seconds, ensur-
ing that the temperature setting is held within a narrow
range.
6