KEC LSM64 Operating Instructions Manual

Manual is about: 6.4" TFT LCD TELEVISION

Summary of LSM64

  • Page 1

    6 . 4" tft lcd television operating instructions professional installation only model : lsm64 for rv-specific dc-only operation please read this entire owner’s manual before using this lcd tv. Important note : when used in a vehicle, this system is intended primarily as a monitor for a video cassett...

  • Page 2

    1 . Read instructions-all the safety and operating instructions should be read before the appliance is operated. 2. Retain instructions-the safety and operating instructions should be retained for future refer- e n c e . 3. Heed warnings-all warnings on the product and in the operating instructions ...

  • Page 3

    We strongly recommend that you carefully read all of the descriptions and operation procedures con- tained in this owner's manual prior to operating your new lsm64. Cautions ·························································· 2 important safeguards ············································...

  • Page 4

    6.4 inch tft lcd panel 12 volt dc operation frequency synthesizer tuning system full on-screen display of all switching functions full on-screen display of all picture functions automatic power shut-off & memory power on functions full remote control high voltage protection (over 18 volts dc) polari...

  • Page 5

    1. Tv/video button press repeatedly to cycle program source selection between tv a/v1 in & a/v2 in & a/v3 in. This button is duplicated on th remote control and tv/set. 2. Tv/catv button this model is not supplied tv/catv button function. 3. Direct channel selection (0 ~ 9) buttons used for the dire...

  • Page 6

    1 1 signal connection • prior to making any connections to your lvs system, be sure to turn power off. • for a more detailed understanding of each connection, it is recommended that you read the instruc- tion manual supplied with each connected cornponent. • the following shows one possible example ...

  • Page 7

    1 3 dome light connection (1) “negative” type door circuit red wire - 12 volt constant power. Brown wire - chassis ground. This wire provides a ground to the dome light circuit when the three (3) position switch is in the “on” position. If this wire is not connected the dome light will not operate w...

  • Page 8

    • insert batteries into the remote control unit by following the "remote control use" section in this manual. • connect the dc cord to 12-volt power by following the "power connection" section in this manual. (1) press power button on the tv or on the remote control. (2) press tv/video button on the...

  • Page 9

    (1) auto program this function allows automatic memorization of all the active tv or cable channels in your viewing area. Once memorized, channels viewing channel list. To activate auto programming, press the set up button until "auto program" is select- ed, then press the volume ( ▲ ) button.The fo...

  • Page 10

    • the picture button on the remote control selects the modes for picture adjustment. • press the picture button on the remote control • press the picture button repeatedly to select the desired item for adjustment. Each time it is pressed, the magenta-colored portion shifts in the order shown below ...

  • Page 11

    (1) quick view button press the q. View button on the remote control. The previously viewed channel will appear on the screen. Press q. View again to switch back to the original channel. Repeatedly pressing q. View switches between these two channels. (2) display button press the display button on t...

  • Page 12

    The most common types of television interference are as follows : ignition noise: black spots or horizontal lines may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electric drills and other electric appliances. Ghosts : ghosts are ...

  • Page 13

    Model no lsm64 television system ntsc-m receiving channels vhf 2~13ch, uhf 14~69ch, antenna impedance 75 ohm display screen display size 6.4 inch (h 130.6mm × v 97.3mm) drive method tft active matrix display format 960 horizontal by 234 vert. Pixels rgb stripe arrangement color depth full color powe...