Summary of K700
Page 1
K700 installation instructions.
Page 2: Contents
Contents general information......................................................................................................3 important points..............................................................................................................3 preconditions..............................
Page 3: General
General * easy to install. Important! Save these installation instructions and the associated firing instructions! Manufacturer's declaration important points * note! Read through all of the installation instructions before beginning the installation. - se. - - - control-area-rules - - 3 -.
Page 4: Preconditions
Preconditions building notice - distance to flammable structural units in the desired place. Top connected - - load-bearing surface floor plate on each side. - outdoor air supply - - densation. Flue - 2 - - ney. Chimney connections the illustration on page 11 shows the distance from the rear edge of...
Page 5: Preparations
Preparations 1. Floor plate and outdoor air connection accessory. Please note that - 2. Flue connection 665 820 return to this at the end of the installation instructions on p. 9. - 5 - 820 665 outdoor air rear installation outdoor air bottom installation floor plate outdoor air rear installation fl...
Page 6
Example a rear connection directly into a chimneybreast or a masonry chimney, e.G. A heda chimney. Mark - installed. - - note! Brick- ing the pipe into the chimney is not allowed. Example b rear connection through a flammable wall - 3. Unpacking - 6 - chimney pre-bushing cut off concrete wall connec...
Page 7: Installation Instructions
- 7 - installation instructions before starting on the installation of the stove, the following steps need to be fully completed: the chimney: outdoor air supply hearth floor plate tip! - hearth..
Page 8
- 8 - - sealed. Note! Always leave at least 10 mm of venti- lated space between the top of the stove and the chimney's insulation/outer steel jacket. (see illustration) - you have now made your stove ready for use. In order for the sealant to harden properly, you must leave the stove for at least th...
Page 9: Care & Firing Instructions
- 9 - care & firing instructions keddy's k700 has been tested by a certified testing institute. It has extremely good environ- mental values and a useful efficiency exceeding 80%. For the stove to work optimally, it is of key importance that you follow the care and firing instructions below. Non-com...
Page 10
- 10 - lighting a fire - (if the chimney is cold or if there are unfavour- able weather conditions, you may need to keep the door ajar during the first couple of minutes in order to establish a satisfactory chimney draught.) - note! The reason why we want to achieve the op- timum operating temperatu...
Page 11: K700 Technical Specification
- 11 - k700 technical specification dimensions and performance rated output 6 kw output 4-9 kw.
Page 12
- 12 - rev 1. 01/05/2015.