Keencut Evolution Evolution Instruction Manual - 2.1
2.1
Before you start
2.1
Overall length of cutter
Worktop
9.5cm
Overall length of cutter
Worktop
15cm
24.5cm
9.5cm
●
Evolution 160cm (64”)
overall length 177.5cm (69.9”)
4 base fixing brackets
●
Evolution 210cm (84”)
overall length 227.5cm (89.6”)
5 base fixing brackets
●
Evolution 260cm (104”)
overall length 277.5cm (109.25”)
6 base fixing brackets
●
Evolution 310cm (124”)
overall length 327.5cm (128.9”)
7 base fixing brackets
●
Evolution 360cm (144”)
overall length 377.5cm (148.6”)
8 base fixing brackets
✍
✍
CHECKING THE BENCH FOR INSTALLATION
■
Do not remove the Evolution from its packing crate until the instruction below
says so.
■
As part of the installation there are a number of checks/adjustments to be made,
it is essential that time is put aside to carry these out properly or the overall
performance of the cutter will be affected.
The Evolution Cutter Bar can be fixed to an existing work bench or to a KEENCUT
bench, the bench must be stable enough so that it does not flex when pushed from the
side and the worktop made from a robust material, firmly fixed to the frame and ideally
flat to within 3mm (1/8”).
The cutter can be fixed along the edge of the bench or slightly inboard but do not mount
the cutter too far away from the edge as it could become difficult or uncomfortable to
operate if you have to lean too far over when making a cut.
If the cutter is to be mounted along the edge of the bench draw a line
9.5cm
in from the
edge of the worktop and the length of the cutter as listed below.
Should you want to use the cutter, say, 15cm in from the edge draw the line
15 + 9.5 = 24.5cm
from the edge of the worktop.