Keepower Classic User Manual - English
Classic 6V
Keepower 6V
Nominal battery voltage 6V
Charge current 0.8
A
Keepower 6V
Nominal battery voltage 6V
Charge current 0.8
A
Fully charged
Charging
Fully charged
Charging
•
Battery acid is highly corrosive. Acid on the clothes should be rinsed off immediately in running water. Acid on the skin or in
the eyes, rinse thoroughly in running water and contact a doctor.
•
A battery produces explosive gases during charging and good ventilation should therefore be ensured if charging takes
place indoors.
•
The charger have to be placed upright on a solid surface or hanged on the wall with the possibility for good ventilation.
•
The charger may not be covered or exposed to direct sunlight.
•
The battery manufacturer advices have to be followed carefully.
•
The charger can only be used for rechargeable lead/acid batteries.
•
Do not recharge non-rechargeable batteries.
•
The charging wires can only be changed to other keepower wires.
•
If the supply cord is damaged, it must be replaced by authorised shop.
•
Repair of the charger may only be done by an authorised shop.
•
The charger is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the charger by
a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
English
Keepower Classic 6V battery charger
The battery charger can be set up in 4 different positions:
Battery charger set-up
As a mobile unit
As a stationary unit
1
230V ~
2
Protect charger from moisture and keep dry.
Riskofexplosion!Avoidfire,openflameandsparks.
Turn off the charger before attaching and removing the charging clamps.
•
thebatteryterminalnotconnectedtothechassishastobeconnectedfirst.
The other connection is to be made to the chassis, remote from the battery
and fuel line. The battery charger is then to be connected to the supply mains;
•
after charging, disconnect the battery charger from the supply mains. Then remove the
chassis connection and then the battery connection.
Before charging, please read this guide instruction.
As a device on
the wall
As a device
hanging on an
edge.
Safety instructions
!
BATTERY CHARGER FOR 6V LEAD ACID BATTERIES
!