KEEWAY HURRICANE User Manual - page 8
Here we introduce some simple ways of checking and adjusting your
motorcycle
BRAKES
Disc Brake Checking
Check from the back of the brake fixture. If the discs appear heavily
abraded, replace the two discs with new ones
Brake Oil Replenishment
If brake oil level is below minimum, replenish with brake oil DOT3 or
DOT4
Pinch rear brake handle till resistance increases and measure if the
further stroke is in the stated range
Adjust the stroke by turning the regulating nut to the right to increase
the travel distance or to the left to decrease same
CAUTION
Do not use inferior quality brake oil
Prevent brake oil from cohering on the paintwork to avoid fading or
chapping
CATION:
Be sure to keep the foveae of the adjusting nut in perfect contact with
the pillar surface of the pin
ADVICE:
Check the travel distance of the grip again after adjustment
Squeeze the brake grip tightly to check if the displacement of the
indicating line falls within the indicated brake limit
ENGINE Oil
Checking Oil
level
1 Open the seat cushoin
2 Remve oil cap. Oil should bebetween maximum and minimum levels
3 Add specified oil if requiredcheck oil level periodically.
CAUTION:
Use of non-standard or low quality engine oil may damage the engine
Use main support on flat ground
Remember to change engine oil regularly
Engine Oil Replacement
1.Remove drain screw of oil cap
2.Drain engine oil (It is easier to drain
the engine oil when the engine is warm)
3.Pour proper quantity of oil slowly into the gear box
4.Tightendrain screw
5.Tighten the oil plug after completion