Keithley PIO-96 Instruction Manual - page 19
PIO-96 User’s Manual
Installation
2-3
Install the DriverLINX software and board as follows:
1. Place the DriverLINX PIO Series CD-ROM in your drive and wait a few seconds. On most
systems, setup starts automatically. If not, run the setup.exe file, found in the root directory
of the CD-ROM.
A DriverLINX Browser Introduction screen
appears. Thereafter, the
DriverLINX CD Nav-
igator screen appears automatically after waiting a few seconds or after clicking
Next
.
NOTE
On the DriverLINX CD Navigator and other DriverLINX Browser
screens, place the cursor over a menu item to see an explanation. A star
next to a menu item means that it was selected previously.
Before continuing with this installation, Keithley suggests clicking
Read
Me First
on the DriverLINX CD Navigator and reviewing the brief
information that appears.
2. On the DriverLINX CD Navigator screen, click
Install DriverLINX
. An Install These
DriverLINX Components screen appears.
3. Click
Install Drivers
, and then follow the series of on-screen instructions. When done, the
Install These DriverLINX Components screen reappears.
4. If you do not plan to develop custom application software for your PIO-96 board, then skip
to Step 5. If you do plan to develop custom application software, you must install Driver-
LINX interfaces before writing the software. Install them now by clicking
Install Inter-
faces
and following the series of on-screen instructions. When done, the Install These
DriverLINX Components screen reappears.
5. Click
Install Documentation
and follow the series of on-screen instructions. This step
installs the manuals. When done, the Install These DriverLINX Components screen reap-
pears.
6. If Acrobat Reader is not already installed on your system, install it now. You need Acrobat
Reader to read the manuals, a section of which you must access in step 9. Click on
Install
Acrobat
and follow the series of on-screen instructions. When done, the Install These
DriverLINX Components screen reappears.
7. Click
Exit.
Then, on the screen
that appears saying “Thank you for using DriverLINX,”
click
Done
. The System Settings Changed dialog box appears.
8. On the System Settings Changed dialog box, click
No
. (The system will be rebooted and
configured later under “Configuring your installation” on page 2-4.) The screen returns to
the Windows desktop.
9. Print out one section of a DriverLINX manual that you will briefly review later during sys-
tem configuration. Proceed as follows:
a. In the
Start
menu under
Programs
→
DriverLINX,
click
On-line Manuals.
A menu
document appears
b. In the menu document, scroll until you find the major category
Configuration
.
c. Under
Configuration
click
Hardware References
. A list of documents appears.
d. In the list of documents, click
Keithley PIO Series
. Acrobat Reader opens and the
manual entitled
Using DriverLINX with Your Hardware—Keithley PIO Series
appears.