Discriminate volume on / off sensitivity pinpoint 5 mp pro high performance – deep searching 0 1 3 2 4 5 6 7 8 9 10 pre set pre set 0 1 3 2 4 5 6 7 8 9 10 0 1 3 2 4 5 6 7 8 9 10 pre set www.Kellycodetectors.Com 1085 belle avenue, winter springs, fl 32708 407-699-8700 owners’s manual high performance...
11 2 glossary of terms air test - a sensitivity test performed by outwardly moving various sized metal samples under the metal detector search- coil to measure the distance limit of detec- tion. This test is not always an accurate indicator of ground depth penetration ca- pability. (see bench test) ...
Assembly — 1. Unpack your metal detector carefully. Slip the lower stem into the middle stem. Adjust the stem length and coil angle. The stem length is adjusted by loosening the lower lock nut and allowing the spring clip to snap into one of the holes in the center stem. The coil angle is adjusted b...
4 9 in the field tip for using your mp5 pro detector 2. Correct arm position. Adjust the lower stem so that your arm is hanging in a comfortable position by your side with the coil about 1 inch off the ground. 1. Always keep the bottom of the coil level with the ground. Try to maintain coil 1 inch o...
5 8 using the mp5 pro metal detector — the mp5 pro is a slow motion type detector, in other words the coil must be in slow motion to respond to any target. By simply moving the coil back and forth over the ground this motion will activate the automatic ground balance and tuning circuits of you detec...
7 6 the discriminate control is used to reject or discriminate unwanted trash targets. When the control is set to '0' your mp5 pro will be in the all-metal mode and will respond to all targets. When you increase the control to a higher number the detector will begin to reject small iron targets firs...
