Kelty KIDS SPEEDSTER Instructions Manual - Tips
5
SETUP / ADJUSTMENT
- FRONT WHEEL -
Figure 1A
1. FRONT WHEEL ATTACHMENT
A. Make sure the front wheel quick-release mechanism is
in the “OPEN” position (Figure 1A).
B. The front brake, on the Deluxe and Deuce stroller
frame, also has a quick-release mechanism. Make
sure the quick-release lever on the front brake is in
the open position (Figure 1B).
C. Insert the front wheel axle into the fork ends
(Figure 1C).
D. Secure the wheel in the fork by moving the quick-
release lever into the “CLOSE” position (Figure 1D).
E. Check to make sure the front wheel is securely
attached to the fork by pulling on the wheel, trying to
remove the wheel from the fork ends (see note).
TIPS
NOTE:
The front wheel
axle may need to
be tightened onto
the fork.
To tighten, place
front wheel in the
fork and twist the
end cap clockwise.
The end cap is
opposite the
quick-release
lever.
Figure 1B
Figure 1C
Figure 1D
Please Note: Your new Kelty Jogging Stroller comes collapsed /
folded for ease of shipping. It must be set up and adjusted prior
to use.
Unpacking:
Remove the stroller frame and wheels from the carton. The carton for your Kelty
Stroller contains the following:
1 – Jogging Stroller Frame
1 – Quick-Release Front Wheel
2 – Quick-Release Rear Wheels
1 – Wrist Leash
Handle Bar
Height Adjustment
(Deluxe & Deuce only)
Hand Brake
(Deluxe & Deuce only)
Bell
(Deluxe & Deuce only)
Yellow Handle Lock
Sun Hood
5-Point Harness
Full Coverage Fender
Quick-Release Wheels
Parking Brake
Locking Side Brace
4
STROLLER FEATURES
-BEFORE YOU START-
CARE AND CLEANING
• Clean with mild detergent and a damp cloth.
• Allow stroller to air dry.
• Do not use bleach or liquid detergent.