Kelvinator KIUF185HWF Instruction Booklet - page 11
21
Réversibilité de la porte
La porte de ce congélateur est réversible: les sens
d’ouverture peut être modifié en fonction du souhait
de l’utilisateur.
Pour changer le sens d’ouverture de la porte
1. Débranchez l’appareil et procédez comme
indiqué ci-dessous.
2. Otez la grille d’aération (D) qui est fixée par un
ressort.
3. Démontez la charnière inférieure (E) en
dévissant les vis de fixation.
4. Dégagez la porte supérieure du pivot (G).
5. Enlevez le pivot et montez-les sur l’autre côté.
6. Enlevez les deux caches, de façon à découvrir
les trous pour les pivots de la charnière, et
remontez-les de l’autre côté.
7. Remontez la porte.
8. Dévissez le pivot de la charnière (E) avec une clé
de 10 et montez-le sur l’autre côté de l’appareil.
9. Vissez la charnière inférieure (E) sur le côté
opposé en utilisant les vis enlevées
précédemment.
10.Détachez le cache (F) de la grille de ventilation
(D) et remontez-le de l’autre côté.
11.Remontez la grille d’aeration (D).
12.Dévissez la poignée. La remonter de l’autre côté
après avoir percé les bouchons avec un poinçon.
Couvrez les trous libres avec les bouchons
contenus dans le sachet de la documentation.
La réversibilité des portes une fois effectuée,
contrôlez que les joints magnétiques adhèrent à la
carrosserie. Si la température à l’intérieur de la
pièce est trop basse (en hiver, par exemple), il se
peut que les joints n’adhèrent pas parfaitement.
Dans ce cas, si on ne veut pas attendre que les
joints reprennent leurs dimensions naturelles après
un certain temps, on pourra accélérer ce processus
en chauffant la partie intéressée à l’aide d’un sèche-
cheveux.
F
D
PR18
F
F
F
E
E
G
PR220
32
CONTENTS
Warnings
31
Use
33
Cleaning the interior
33
Starting
33
Temperature regulation
33
Quick-freezing
33
The temperature alarm light
34
Freezing fresh food
34
Storage of frozen food
34
Thawing
34
Ice-cube production
34
Cold accumulators
34
Freezer calendar
35
Hints
35
Hints for freezing
35
Hints for storage of frozen food
35
Maintenance
36
Periodic cleaning
36
Periods of no operation
36
Defrosting
36
Customer service and spare parts
37
Technical Information
37
Installation
38
Location
38
Rear spacers
38
Electrical connection
38
Changing the opening direction of the door
39
•
Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance. Do not use a
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important:
if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol
are recyclable.
Disposal of old Appliances
The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product, please
contact your local city office, your household waste
disposal service or the shop where you purchased
the product.