Inverter split-type room air conditioner installation manual ksv26hrb, ksv35hrb, ksv53hrb, ksv62hrb, ksv70hrb, ksv80hrb refrigerant r410a.
Warning do not install yourself. Incorrect installation could cause injury due to fire, electrical shock, the unit falling or leakage of water. Consult the dealer from whom you purchased the unit or authorised installer. Perform the installation securely referring to the installation instruction. In...
Kelvinator air conditioning typical installation 5 4 before installation kelvinator air conditioning caution • use a stud finder to locate studs to prevent unnecessary damage to the wall. • a minimum pipe run of 3 metres is required to minimise vibration & excessive noise. • two of the a, b and c di...
• ensure that the clearance around the back of the unit is more than 30cm and more than 30cm on the left side. The front of the unit should have more than 2.0m of clearance and the connection side (right side) should have more than 60cm of clearance. • do not place animals and plants in the path of ...
Kelvinator air conditioning installation 9 8 installation kelvinator air conditioning upper hook lower hook cushioning material 5. Piping and wrapping bundle the tubing, connecting cable, and drain hose with tape securely and evenly as shown page 13. • because the condensed water from rear of the in...
Kelvinator air conditioning refrigerant pipe connection 11 10 installation/refrigerant pipe connection kelvinator air conditioning bar copper pipe clamp handle red arrow mark cone yoke handle bar "a " tightening connection • align the center of the pipes. • sufficiently tighten the flare nut with fi...
Kelvinator air conditioning refrigerant pipe connection 13 12 refrigerant pipe connection kelvinator air conditioning for rear left piping note: when viewed from the front of the indoor unit. A: route the indoor tubing and the drain hose to the required piping hole position in the direction of left....
Kelvinator air conditioning refrigerant pipe connection/electrical work 15 14 refrigerant pipe connection kelvinator air conditioning connect the cable to the indoor unit • connect the cable to the indoor unit by connecting the wires to the terminals on the control box individually according to the ...
Kelvinator air conditioning electrical work/checking the drainage and forming piping 17 16 electrical work kelvinator air conditioning checking the drainage a: to remove the front panel from the indoor unit. • pull the lower left and right sides of the grille towards you and lift it up. Downward s l...
Kelvinator air conditioning air purging/test running 19 18 checking the drainage and forming piping/air purging kelvinator air conditioning safety and leakage check electrical safety check perform the electrical safety check after completing the installation: 1 grounding work after finishing groundi...
Kelvinator air conditioning notes 21 20 test running kelvinator air conditioning pump down this is performed when the unit is to be relocated or the refrigerant circuit is serviced. Pump down means collecting all refrigerant in the outdoor unit without loss of refrigerant gas. Caution be sure to per...
22 notes kelvinator air conditioning notes kelvinator air conditioning warranty 23 this document sets out the terms and conditions of the product warranties for electrolux appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future referen...
P/no. 1452635 © 2011 electrolux home products pty ltd abn 51 004 762 341 print code: kfixinvum_jul11 if you’d like further information about kelvinator appliances, please visit your retailer, phone or email our customer care team or visit our website. Telephone: 1300 363 640 fax: 1800 350 067 email:...
