Kelvinator KWH20HRB User Manual - Installation Steps

14

Step 2. Remove the frame.

1. Remove the two fixing screws from the frame (See Fig.3).

2. Grasp the left corner of the frame's underside, release the coupler plugs, 

    then loosen the frame (See Fig.4). 

Step 3. Installation.

1. Remove the two fixing screws on the chassis fixing brackets, then remove the chassis fixing brackets

   (See Fig.5).

2. Grasp the handle on the chassis and carefully slide the air conditioner out of the cabinet (See Fig.6).

3. Make sure the discharge points to the drain pan are aligned before the chassis is pushed into the 

    cabinet (See Fig.7).

4. Push the unit chassis into the cabinet (See Fig.8).

5. Install the two chassis fixing brackets using the two fixing screws (See Fig.5).

Step 4. Install the frame.

1. Install the frame and connect the coupler plugs, making 

    sure not to interfere with the  temperature  sensor cable  

    (See Fig.9).

2. Fix the screws on the frame (See Fig.3).

Step 5. Install the air filter and front panel.

1. Install the air filter into the frame's slot from upside to 

    underside (See Fig.2).

2. Hang the front panel on the frame's buckle, then  press the 

    front panel into the frame's slot until you hear a click (See Fig10).

Installation Steps

Step 1. Remove the front panel and the air filter 

1. Hold the slot under the front panel, then uplift it outwards, and remove the front panel (See Fig.1).

2. Pinch the handle under the air filter and make the air filter arched, remove it from the slot from underside

    to upside (See Fig.2).

6

4

5