Ken A Vision Ceiling DocCam II Installation & Operation Manual - page 8
7
Installation
Before you install
The following equipment is needed for proper installation:
• String or plumb bob
• Utility knife
• Flathead screwdriver
Be sure to check above the ceiling tile where you plan to install the camera to make sure
the area is clear and that there is enough room for the Ceiling DocCam™ II and all of its
components. Use the string or plumb bob to align and center the camera directly above
the viewing area. Use the utility knife to cut a hole in the tile and the screwdriver to attach
the white trim ring to the camera enclosure.
Mounting the camera
The Ceiling DocCam II is an integrated document/object camera designed to be installed
in a suspended ceiling above a table. Recommended ceiling heights are between 8 and
12 feet. The camera module enclosure and the tile support rail allow for exceptional
positioning freedom when used with 2'x2' and 2'x4' ceiling tiles. The camera may be used
with any tile 2' wide. The tile support rail distributes the weight of the camera into the grid
and prevents tile warping. The diagram in Figure 5 shows the completed installation.
Installation
6
Remote
A. Flip. Rotates image 180° on video display device.
B. Freeze. Freezes current image until you press again to release and return to live view.
C. Focus. Focus Near for close up views. Focus Far for distance views.
D. Cam Laser. Displays a laser pointer with momentary on (5 seconds) and auto off.
Use the laser pointer to position documents directly under the camera.
E. Presents. Stores up to six programmed camera setting presets (0-5).
F. Set. Press to program presets.
G. Neg/Inv. Makes image a negative. This is useful in hiding highlighted portions of
documents, by making them appear not highlighted.
H. Brightness. Auto automatically adjusts brightness, (+) manually brightens image
and (-) manually dims image.
I.
B/W. Black/White displays image in black and white.
J. Zoom. Zoom In zooms for small images such as a stamp. Zoom Out zooms out for
large images or documents such as a blueprint.
K. Auto Focus. Automatically focuses an image.
L. Power. Turns the camera on or off.
M. Display. Shows icons for all camera controls and any messages associated with
the presets
Introduction
OUT
PRESETS
0
1
2
3
4
5
SET
NEG/INV
B/W
BRIGHTNESS
-
+
AUTO
CAM
LASER
PWR
FLIP
FREEZE
AUTO
FOCUS
DISPLAY
ZOOM
IN
ZOOM
A
C
D
E
F
G
H
I
B
J
K
L
M
Figure 4. Ken-A-Vision
®
remote
Figure 5. Complete installation
Power
adapter
25' S-video
cable
50' Cat 5 cable
RS-232
Serial Control Panel
Video Codec
Television
or