Video flex 7000 series instruction manual 7100 7100p 7200hd 7300 7300p 7600 7600p.
2 video flex 7000® series instruction manual thank you for your purchase of a ken-a-vision video flex ® 7000 series camera! You have acquired a high resolution solution to any presentation need, be it classroom or conference room. Images captured by your camera will be transmitted directly to your t...
3 if any components are missing, please contact your authorized ken-a-vision ® dealer. Setting up and using your video flex ® is as easy as 1, 2, 3... 1. Connecting the video flex ® to power supply 7100, 7100p, 7300, 7300p, 7600, 7600p: first prepare your switching (automatically switches from 110v ...
4 now plug the small, round male plug at the other end of the power supply, into the video flex ® camera, in the slot marked pwr, in the middle back of the unit. Plug the video flex ® camera unit into your power source. If unit was purchased or shipped to the country of use, the plug has the correct...
5 (plug on back of unit, at the far left of center). If unit is powered up and red light of unit is on, video image from camera should appear on your s-video output device. • tv/monitor connect the composite (rca type) yellow video cable or the s-video cable from the video flex ® camera into the "vi...
6 dependent upon your computer set up. See the owner's manual of the computer for the operating procedures. Note 1 : the usb cable provides ample power to the camera, no separate power supply needed. Note2: on the 7600 and 7600p, if the usb is connected, the power supply does not need to be connecte...
7 7600, 7600p (in digital mode), 7200hd on the 7600/7600p units, the switch on the base can be used even when camera in digital operation. But additionally the positive/negative image may be toggled on/off using the applied vision™ software. (if your version of applied vision™ software does not have...
8 clockwise direction, adding an additional amount of force to lock it in place. 7. Focusing: the video flex ® uses the patented quick focus ® c-mount lens. The focusing ring, located on the camera head, is similar to that of a 35mm camera. The new ergonomic design makes focusing with one hand a sna...
9 note: before installing the microscope eyepiece adapter, measure the size of the outside diameter of the microscope eyepiece to be sure adapter will fit over the end of the eyepiece. Remove the rubber eyecup if present. 1. Place the microscope eyepiece adapter over one (if dual-headed or binocular...
10 o one of the small plastic specimen holder envelopes and the box holder. The bags are held by the small slit in the ends of the box holder. • now place the shaft of the holder into the small opening located at the end of the telescoping tube. • adjust the telescoping tube and attachment holders t...
11 video flex ® accessories expand the capabilities of your video flex with accessories. Additional accessories are available on our web-site at www.Ken-a-vision.Com. Replacement parts vfds..................Discovery scope kit vfpseu..............Discovery scope kit 2200 vfpsusa............Power sup...
5615 raytown road • kansas city, mo 64133 u.S.A. Tel.: 816-353-4787 • fax: 816-358-5072 email:info@ken-a-vision.Com • www.Ken-a-vision.Com ins-vf7 camera complies with class a and b, part 15 of the fcc rules. Use only ken-a-vision video flex parts. The power supply and charger are made exclusively f...
