Ken A Vision VisionScope 2 T-22001 Instruction Manual - Troubleshooting
of
12
Troubleshooting
This section provides some useful tips on how to solve common
problems while setting up or using the VisionScope 2:
I can’t see an image. I only see a partial image.
• Check to see if the power supply is plugged into an
outlet/or charged if cordless.
• Check to see if the LED lights are turned on.
• Check to see if the dimmer switch is turned to allow the
intensity of light to increase.
• Check to see if the objective lens is clicked into place.
It is difficult to get the image in focus.
• Adjust the coarse focus knobs slowly.
• Change the objective until you hear it click in place.
• Adjust the eyepieces and the diopter slowly until you see one
focused image.
11