Kendo ST737 Operating Instructions Manual - page 4
7
6
Tuning your video recorder to the television
If you already set the language and country set, you can see the followings.
If you do not see this picture, check that the video is
connected properly.
Press OK for ‘Auto Set’ or ‘Auto Search’.
1
2
What to do if you get picture interference when using RF lead
Option 1
If other stations are positioned on or near the current RF OUTPUT CH, the following guide message
appears automatically.
The RF output can be adjusted from 21 to 69, this video is defaulted to RF52. If other
broadcasts are close to RF 52 they may cause picture interference, you can change the
RF output until your television has a noise-free channel for your video.
Change the RF output from 52 using the remote control.
Press MENU. Select ‘VCR Set Up’ by pressing PR- twice then OK.
Select ‘RF Output Set Up’ by pressing PR- twice then OK.
Change the channel number using buttons 0-9.
Press OK to confirm. Press MENU to end.
Option 3
Buy a scart lead from your local electrical shop. Connect the scart lead as shown on page
2, diagram 2.
If you want to change the RF output in the future due to new broadcasting stations or equipment
and so on, press and hold the OK button on the remote control until RF 52 is displayed on the front
of the video. Then go to option 2 above.
PLEASE CHANGE THE TV
CH TO 54.
IMPORTANT!
Press OK to confirm.
Press MENU to end.
Option 2
RF OUTPUT SET
0-9:SET UP (21-69)
OK:CONFIRM MENU:END
CH 52
If there is still picture interference repeat option2.
RF OUTPUT SET
OK:CONFIRM MENU:END
CURRENT
CH 52
RECOMMENDED CH
54
MENU:END
PLEASE WAIT...
CH 25
Unless you are living in an area with poor reception, ‘Auto
Set’ or ‘ Auto Search’ tunes in all the stations you can
receive in your country and sorts them in a common order,
for example, ARD on programme 1, ZDF on programme 2
and so on.
See page 10 and page 11 if you need to change any of the
automatic settings. You should finish the auto set before
you go to page 10 or page 11.
The clock is also set automatically. If the clock has not
been set, the clock setting screen will appear.
Please see “ Setting time and date” on page 17.
If you want to change the station names, see page 10.
If you want to change the programme locations see page
11. You need to change programme locations if the
stations are not in order, for example, ARD on programme
1, ZDF on programme 2 and so on.
Press MENU to end.
MANUAL SET
PR01 P-01
PR08 P-08
PR02 P-02
PR09 P-09
PR03 P-03
PR10 P-10
PR04 P-04
PR11 P-11
PR05 P-05
PR12 P-12
PR06 P-06
PR13 P-13
PR07 P-07
PR14 ----
PR+/-:SELECT
OK:CONFIRM MENU:END
Important: If you switch the video off at the mains supply overnight, you do not have to
retune the video. Simply press
and then MENU on the remote control to restore all the
program settings. See page 17 to set the time and date.