Summary of EUN2243AOW
Page 1
Benutzer- information gefrierschrank gebruiksaanwi jzing vriezer notice d'utilisation congélateur user manual freezer ite127-9.
Page 2
Contents safety information 40 control panel 42 first use 43 daily use 43 helpful hints and tips 43 care and cleaning 44 what to do if… 45 technical data 47 installation 47 environmental concerns 51 subject to change without notice safety information in the interest of your safety and to ensure the ...
Page 3
• it is dangerous to alter the specifications or modify this product in any way. Any dam- age to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personn...
Page 4
Environment protection this appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be dis- carded together with the urban refuse and rubbish. The insulation foam con- tains flammable gases: the applianc...
Page 5
First use cleaning the interior before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand- new product, then dry thoroughly. Important! Do not use detergents or abra- sive powde...
Page 6
• do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; • lean foods store better and longer than fatty ones; salt reduces the storage life of food; • water ices, if consumed immediately after removal from the freezer compartment,...
Page 7
Defrost the freezer when the frost layer rea- ches a thickness of about 3-5 mm. Important! About 12 hours prior to defrosting, set the temperature regulator toward higher settings , in order to build up sufficient chill reserve for the interruption in operation. To remove the frost, follow the instr...
Page 8
Problem possible cause solution the appliance does not operate. The pilot light does not flash. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. The...
Page 9
Technical data dimension of the recess height 880 mm width 560 mm depth 550 mm rising time 20 h the technical information are situated in the rating plate on the internal left side of the ap- pliance and in the energy label. Installation read the "safety information" carefully for your safety and co...
Page 10
Ventilation requirements the airflow behind the appliance must be sufficient. Min. 200 cm 2 min. 200 cm 2 installing the appliance caution! Make sure that the mains cable can move freely. Do the following steps: 1. Install the appliance in the niche. Push the appliance in the direction of the arrows...
Page 11
I 4. Push the sealing strip between the ap- pliance and the adjacent cabinet. 5. Remove the correct part from the hinge cover (e). Make sure to remove the part dx, in the case of right hinge, sx in op- posite case. 6. Attach the covers (c, d) to the lugs and the hinge holes. Attach the hinge covers ...
Page 12
Ha hc 10. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (hb) into guide (ha). Put together the appliance door and the furniture door and mark the holes. Ha hb 8 mm 11. Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the do...
Page 13
• the magnetic sealing strip is attached tightly to the cabinet. Important! If the ambient temperature is low (for example, in the winter), the size of the gasket decreases. The size of the gasket increases when the ambient temperature increases. You can also use a hairdryer to increase the size of ...